How to Replace the Wiper Blades on a Mercedes-Benz E300?
3 Answers
The method for replacing the wiper blades on a Mercedes-Benz E300 is as follows: 1. Push the wiper arm in the direction of the car's front until it locks into position at a certain angle. Press the wiper's release button while gently rocking the entire wiper blade upwards to remove the old rubber blade. 2. Release the two clips securing the wiper blade and pull out the old rubber blade. 3. After successfully installing the new rubber blade, reassemble the wiper by following the removal steps in reverse order. The Mercedes-Benz E300 is a mid-to-large-size sedan produced by Beijing Benz, with dimensions of 5078mm in length, 1860mm in width, and 1484mm in height, and a wheelbase of 3079mm. It is equipped with a 1.5T turbocharged engine delivering a maximum power of 135kw, paired with a 9-speed automatic transmission.
Once when I was driving my Mercedes-Benz E300 in the rain and the wipers weren’t cleaning properly, I decided to replace the wiper blades myself. First, I had to turn off the engine, then press the wiper control stalk on the right side of the steering wheel downward for a few seconds to enter maintenance mode—this causes the wipers to lift upright. Next, I pressed the small tab at the wiper arm connection point, heard a click, and pulled out the old wiper blade. When installing the new wiper, I made sure to align the arrow direction correctly, inserted the metal hook into the wiper arm all the way, and the tab automatically locked into place. Finally, I remembered to exit maintenance mode in the settings menu and tested the new wipers with some windshield washer fluid. The whole process took me about 20 minutes. When buying wiper blades, it’s important to choose the Mercedes-specific connector and avoid cheaper, incompatible models.
I've replaced the wiper blades three times in five years of driving my Mercedes-Benz E300. First, completely turn off the engine; otherwise, the wipers won't move. Navigate to the vehicle settings in the dashboard menu and activate the wiper service position. At this point, the wiper arms will lift up for easier access. Then, locate the silver clip at the wiper arm connection, pinch it, and push outward to slide out the old wiper blade. When installing the new blade, ensure the rubber isn't twisted, align the connector properly, and push it in until you hear a click to confirm it's securely locked. Don't forget to deactivate the service mode afterward, and when testing, avoid dry wiping—spray some windshield washer fluid for lubrication. It's recommended to check the rubber for wear every six months.
