How to Replace the Wiper Blades on a Haval H6?
2 Answers
Here are the steps to replace the wiper blades on a Haval H6: 1. Activate the wiper control switch: Turn the ignition switch to LOCK mode, pull the wiper control switch vertically upward, and hold for about 3 seconds. The wipers will automatically move to the service position. 2. Lift the wiper arm: Lift the wiper arm away from the windshield. 3. Remove the wiper blade: Detach the wiper blade from the wiper arm. 4. Install the new wiper blade: Attach the new wiper blade and place the wiper back onto the windshield. 5. Reset the wipers: Return the wipers to their initial position. Turn the ignition switch to ON mode or start the engine, and the wipers will automatically reset to their initial position.
As a seasoned auto repair veteran with years of experience, I've helped replace Haval H6 wiper blades dozens of times. Step one is to turn the key to the ACC position or turn off the engine to prevent the wipers from automatically activating and causing injury. Then gently lift the wiper arm to angle the blade away from the windshield—never let it snap back and risk shattering the glass. Locate the connection point; Haval's clips usually have a small plastic button—press it while pulling the old blade straight out. When buying new wiper blades, note your car's model year. The H6 commonly uses 26-inch and 18-inch sizes—just purchase the specific model online or at an auto parts store. When installing the new blade, push it all the way in until you hear a click to lock it in place. Test by spraying water and turning on the wipers to check for a clean sweep. Haval's design is quite sturdy and easy to maintain. I recommend replacing them every six months or before the rainy season to extend their lifespan and ensure safer driving.
