How to Replace the Wiper Blades on a BMW X4?
3 Answers
BMW X4 wiper blade replacement method mainly includes: 1. Press the start button to turn off the vehicle power. 2. Push the wiper lever on the right side of the steering wheel upward and hold for three seconds. 3. After the wiper enters the automatic cycle mode, release the wiper lever. 4. After two cycles, the wiper will stop in the appropriate position. 5. Then simply lift the wiper, press the button to pull out the old wiper blade upward, and install the new wiper blade into the slot to complete the replacement. Additional information: Wiper blade removal method: 1. First, fully raise the wiper arm. To avoid damaging the windshield during the removal or installation process, it is recommended to place a cloth on the windshield when removing or installing the wiper. Lift the wiper arm and adjust the blade angle. 2. Next, adjust the angle of the wiper blade, preferably to a 90-degree angle with the wiper arm. Since the wiper blade is secured to the arm with a clip, adjusting the angle facilitates removal and installation. 3. After positioning the blade at the correct angle, begin the removal process. First, use one hand to lift the rubber blade to expose the fixing hook between the wiper arm and the blade. Remove the entire wiper blade assembly. With one hand, pull the rubber blade sideways while pressing down firmly on the main bracket with the other hand to separate the wiper blade from the arm. After this, the entire wiper blade can be removed.
As a long-time BMW owner, I'd like to share some experience: You don't need to go to a 4S店 for wiper replacement, it's super convenient to do it yourself. The BMW X4's wiper system features a U-hook design. First, turn the key to ACC position and turn off the engine to prevent accidents. Push the wiper arm to the upright position, locate the clasp button or lock at the connection point, and gently press or flip it to remove the old wiper blade. Remember the sizes: typically 24 inches for the driver side and 20 inches for the passenger side - make sure to match the model when buying new wipers. During installation, align the wiper arm's hook and snap in the new wiper until you hear a 'click' indicating it's locked. Always clean dust residue from the wiper arm and glass during operation, otherwise the wiper may jump or produce noise. For testing, spray windshield fluid and check if wiping is even and quiet. The entire process takes under 5 minutes. Checking wiper wear every six months can extend service life and save money.
DIY enthusiast here! I often replace the wiper blades on my BMW X4 myself, which is super simple and convenient. First, prepare new wiper blades—24 inches for the driver side and 20 inches for the passenger side—just buy them online, no need for OEM parts. Then, park the car and turn off the engine, push the wiper arm to the service position: press the release button below the windshield to make the wiper stand upright. Next, locate the clip connecting the wiper arm and the wiper, press to unlock it, and gently pull out the old wiper. To install the new wiper, align it with the U-hook and push it straight in, ensuring smooth movements to avoid damaging the glass. The key point is to thoroughly clean the wiper arm surface—wipe off old rubber debris with a damp cloth to prevent the new wiper from leaving streaks. After installation, test with windshield washer fluid to ensure no streaks. It’s recommended to check the wiper condition monthly and replace aging ones to save money and hassle.
