How to Replace the Seat Belt Buckle on Arrizo 5

How to Make a Turn in an Automatic Transmission Car?

To make a turn in an automatic transmission car: 1. When making a left turn at an intersection, the driver should signal in advance and stay as close as possible to the centerline of the road to facilitate vehicles behind and those making right turns; 2. When making a right turn, signal in advance, turn slowly to prevent the right rear wheel from going off the road and potentially hitting pedestrians or obstacles on the roadside; 3. The driver should slow down within 50 to 100 meters, honk the horn in advance, and indicate the direction of movement with turn signals or hand gestures. An automatic transmission does not require the driver to manually shift gears; the vehicle will automatically select the appropriate gear based on the driving speed and traffic conditions.

19

5

Share

Why does the engine malfunction indicator light come on in a new car?

New car engine malfunction indicator light comes on because there is a fault in the engine. This situation in a new car is considered a factory quality issue, and it is recommended that the owner promptly visit a 4S dealership to request warranty repair. After the engine has been used for a period of time, carbon deposits will accumulate, which can lead to engine damage, difficulty starting, poor acceleration, excessive engine noise, and other phenomena. The accumulated heat can cause irregular engine ignition, leading to engine knocking. In such cases, the engine malfunction indicator light will illuminate. Carbon deposits in the engine should be cleaned regularly, typically every 40,000 to 50,000 kilometers. Some owners wait until the malfunction indicator light comes on before checking and cleaning the carbon deposits on the engine.

15

1

Share

What Causes Transmission Abnormal Noise?

Transmission abnormal noise is caused by: 1. Loose connection between the gear lever and shift fork groove in manual transmissions; 2. Loose bolts on the transmission housing; 3. Wear or damage to bearings; 4. Metal peeling on gear tooth surfaces, tooth breakage, or incorrect assembly; 5. Abnormal gear meshing clearance; 6. Water ingress into the transmission; 7. Insufficient lubrication due to inadequate lubricant. The transmission mainly refers to the vehicle's gearbox, which is divided into manual and automatic types. Manual transmissions primarily consist of gears and shafts, achieving speed and torque variation through different gear combinations. Automatic transmissions are composed of a torque converter, planetary gears, hydraulic torque variation system, and hydraulic control system, achieving speed and torque variation through hydraulic transmission and gear combinations.

10

5

Share

What to Do When Wipers Leave Water Marks?

Here are the solutions for water marks left by wipers: 1. Poor quality of new wipers: The rubber is rough, which not only causes water marks (ineffective wiping) but also produces noise. Use sandpaper to smooth it out. 2. Uneven pressure: This leads to ineffective wiping. Adjust the distance between the springs. Alternatively, there may be impurities on the wiper, preventing it from wiping the glass effectively. Clean it if necessary. 3. Oil film on the glass: Oil film has strong water adhesion, making it difficult to remove even with wipers. To check for oil film, pour water on the glass. If small water droplets cling to it, it indicates the presence of oil film. Use a glass cleaner to remove the oil film thoroughly.

3

5

Share

What to Do When the Car Battery Dies Due to Leaving Lights On?

When the car battery is completely drained due to leaving the lights on, the following solutions can be adopted: 1. Push-starting is the most familiar and effective emergency starting method, but it is a last resort and should not be used frequently. This method can cause some damage to the engine and clutch, and automatic transmission vehicles should especially avoid using this method to start. 2. To avoid being unable to charge the battery when it runs out of power, car owners should keep a set of jumper cables in the car as a backup, which can be purchased at most auto parts stores. 3. The lifespan of a car battery is generally 2 to 3 years, so it should be replaced in time when necessary to avoid potential hazards.

20

1

Share

Where is the cabin air filter located in the X3?

x3's cabin air filter is located inside the grille box beneath the windshield wipers. To access it, open the engine hood and first remove the two sealing strips on top, after which you can see the box containing the cabin air filter. The cabin air filter used in vehicles primarily serves to filter out impurities from the outside air. During the operation of the air conditioning system, it prevents external dust from entering the cabin, thereby protecting the health of the vehicle's occupants to a certain extent. Function of the cabin air filter: It ensures that the filter fits tightly against the housing, preventing unfiltered air from entering the cabin. The BMW X3 is an SUV model equipped with BMW's patented xDrive intelligent all-wheel-drive system, with body dimensions of 4648mm in length, 1881mm in width, and 1661mm in height.

18

1

Share

How to Replace the Seat Belt Buckle on Arrizo 5

How to Make a Turn in an Automatic Transmission Car?

Why does the engine malfunction indicator light come on in a new car?

What Causes Transmission Abnormal Noise?

What to Do When Wipers Leave Water Marks?

What to Do When the Car Battery Dies Due to Leaving Lights On?

Where is the cabin air filter located in the X3?

Why does the car start to pull to one side after a wheel alignment?

What does the 'a' in electronic handbrake mean?

How Much Horsepower Does the New 911 Have?

Why does the car shake when starting in first gear?