How to Replace the Remote Battery for Honda Vezel?

1 Answers
LaWilliam
07/29/25 11:44am
Honda Vezel's remote battery replacement method is as follows: 1. Push the switch on the car key; 2. Pull out the mechanical key; 3. Pry open the car key cover; 4. Remove the old battery and insert the new one. Taking the 2020 Honda Vezel as an example, its body dimensions are: length 4328mm, width 1772mm, height 1605mm, wheelbase 2610mm, and fuel tank capacity 50 liters. The 2020 Honda Vezel is equipped with a 1.5L naturally aspirated engine, with a maximum power of 96kW and a maximum torque of 155Nm, paired with a 6-speed manual transmission. Its front suspension uses a MacPherson independent suspension, and the rear suspension uses a torsion beam rear suspension.
Was this review help?
1
2
Share
More Forum Discussions

How to Install Ultrasonic Sensors?

Ground clearance: 50~70cm; Horizontal spacing: The distance between point A and point B, point C and point D should be 30cm. Ensure the arrow direction is facing upwards, then install the ultrasonic sensor. Apply even pressure around the edges of the ultrasonic sensor to press it in, ensuring it fits tightly into the mounting hole. Connect the waterproof and dustproof plug, and tighten it firmly. Determine the wiring length and cut it according to the actual requirements of the vehicle model.
14
2
Share

How to Open the Hood of Lincoln MKC?

The hood release lever of Lincoln MKC is located near the door on the left side below the driver's compartment. Pull this lever to release the hood. Then, look into the slightly opened hood gap from the front left side. You'll find a yellow switch inside. Reach in and flip this switch to fully open the hood.
3
2
Share

How to Disassemble and Clean the Air Conditioner Filter?

There is a black plastic panel above the passenger's footwell area; remove it by prying it off. Next, disconnect the negative terminal of the battery, then remove the body control module and its mounting bracket (typically secured by two 12mm nuts). Finally, remove the panel on the left side of the passenger's left footwell by loosening and taking out the four screws, allowing access to disassemble the car's air conditioning system.
8
2
Share

How to Start a Cadillac?

Shift the gear lever into the P (Park) or N (Neutral) position. The engine cannot be started in other positions. The remote key must be inside the vehicle. After pressing the brake pedal, press the one-touch start button. Release the button once the engine begins to start.
5
0
Share

How to Install a Dual-Camera Dash Cam?

First, determine the optimal installation position for the dash cam. It is recommended to install it on the right side of the interior rearview mirror, as close to the center as possible. Insert the power cable of the dash cam into the gap of the car's headliner. Then, pull down the door frame seal strip and forcefully pry open the A-pillar trim panel with both hands. From the top of the A-pillar, follow the door frame downward while reinstalling the seal strip and tucking the power cable inside it until the cable emerges at the bottom of the dashboard. Pass the power cable behind the glove box and secure it there.
16
0
Share

How to Turn On Daytime Running Lights?

Daytime running lights (DRLs) on cars usually automatically turn on as soon as the vehicle is started or powered on, and they remain lit even if the headlights are turned off. If the lights come on after starting the car, it's mostly due to an additional switch installed by the owner. To turn them on, simply press the switch button that was added.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.