How to Replace the Rear Wiper on the Envision?
3 Answers
Buick Envision Wiper Replacement Tutorial: 1. Remove the original wiper by first lifting it upright. 2. Press the clip at the bottom and remove the wiper blade. 3. Carefully detach the original wiper from one side, being cautious not to let the wiper arm snap back and damage the windshield. 4. Slightly lift the front end of the middle clip to facilitate installation. 5. Insert the middle clip and pull it tight until you hear a click, indicating it's in place. 6. Install the passenger-side wiper, ensuring the correct direction. Similarly, pull it tight until you hear a click. More details below: 1. Among all car components, the Buick Envision wiper is a relatively small part. However, international driving safety surveys show that the accident rate caused by aging wipers in rainy conditions is about five times higher than usual. 2. In seasons with frequent rain showers, if the wiper malfunctions, it should be repaired or replaced immediately. There are generally two types of wipers: the traditional intermittent type, which is the most common and has three to four segments, adjusted by the driver based on rain intensity and visibility; and the rain-sensing type, mostly used in mid-to-high-end models. 3. A good Buick Envision wiper must be heat-resistant, cold-resistant, acid- and alkali-resistant, corrosion-resistant, able to fit the windshield, reduce motor load, produce low noise, have strong water-repellency, and be soft enough not to scratch the windshield, ensuring clear visibility. For driving safety, it is recommended to replace the wiper annually.
I often do maintenance on my beloved car myself, and replacing the rear wiper is no big deal. The rear wiper arm of the Envision is located above the rear window. First, lift the wiper arm to avoid scratching the glass. Locate the connection point between the wiper blade and the wiper arm—there’s usually a small clip or hook mechanism. Gently press or pry it open to remove the old wiper blade. Then, purchase a new wiper blade of the matching model online or at an auto repair shop, making sure to check the exact size for the Envision to avoid buying the wrong one. When installing the new blade, align it with the hook and push it in until it clicks, indicating it’s securely locked. Finally, start the car and test the wiper with water spray to ensure smooth operation; adjust slightly if it’s uneven. It’s recommended to check the wiper blades for wear every six months—failing to replace aged blades can lead to blurred vision during rain, affecting driving safety. Doing it yourself saves a few dozen bucks on fuel costs and enhances your sense of control over the car.
Bro, replacing the rear wiper is super easy. I've done it several times. On the Envision, the rear wiper arm is on top of the rear window—carefully lift it up to avoid dropping it and damaging the glass. The connection point is either a U-shaped hook or a clip with a button; just press the small button firmly or pull off the old wiper blade directly. The key is selecting the correct model for the new blade—just search online for the Envision rear wiper size. When installing the new blade, align it with the hook position, push it in securely, and lock it in place. Start the car and test the wiper to ensure it clears the water properly. Always pay attention to the wiper's condition while driving—if you hear scraping noises or notice water streaks, replace it immediately to avoid obstructed vision and potential accidents. DIY is faster and cheaper than going to a shop; with practice, it takes just a minute. A new rear wiper keeps the glass clear and makes driving more enjoyable.
