How to Replace the Rear Wiper on the Enclave GX?
3 Answers
If you are removing the original wiper, first lift the wiper arm. Then press the clip below to slide it out. Next, remove the original wiper from one side, but be very careful not to let the arm snap back and damage the windshield. Lift the front end of the middle clip slightly to make installation easier. Note that some models have different wiper sizes for the driver and passenger sides, with the driver's side usually being longer and the passenger's side shorter.
I remember replacing the rear wiper of my Enclave GX myself last winter when it kept leaving streaks, which was super annoying. First, check the manual to find out the model is 24 inches—buying a matching beam blade online or at a store saves hassle. Park the car on level ground and turn off the engine, then locate the small button at the base of the wiper arm. Press it gently, and the old wiper will slide out—don’t yank it, or you might damage the glass! Remember to clean any debris off the glass, or the new wiper won’t last long. Align the new wiper’s slot and push until it clicks into place. Test for smooth operation without odd noises. The whole process takes just 5 minutes. I recommend checking the wiper rubber for cracks every six months—spending a few bucks on DIY is cheaper than repairs. With clear visibility, rainy-day driving feels much safer. Why not give it a try?
I was quite nervous the first time I changed the rear wiper, afraid of damaging the car. For the Encore GX, make sure to check the correct model and buy the right parts. It's recommended to measure the size or search online for 'Encore GX rear wiper' to get a branded one. After parking and turning off the engine, lift the wiper arm first, then gently press the clip button to remove the old wiper. Don't forget to clean the window dust, or the new wiper will leave water marks. Align the new wiper and insert it into the arm head, then push it firmly to ensure it's securely fastened. During inspection, turn on the wiper at low speed to see if it runs smoothly. The whole process is very simple, so don't panic if you're a beginner—it takes just 20 minutes and saves you a hundred bucks in labor costs compared to going to a shop. By the way, it's safer to change it once before the rainy season—safety first!
