How to replace the rear wiper of the Encore?
2 Answers
Steps to replace the rear wiper of the Encore: First, lift the wiper arm away from the windshield, keeping it perpendicular to the windshield for stability. Press the tab and remove the old wiper blade, separating it from the wiper arm. Insert the new wiper blade, gently rotating it until the hook snaps into place to secure it. Finally, return the wiper arm to the windshield. Below is an introduction to the Encore: 1. Exterior: The new-generation Encore features a significantly more youthful and stylish appearance compared to the current model. The Encore measures 4295mm in length, 1798mm in width, and 1616mm in height, with a wheelbase of 2570mm. 2. Interior: The new Encore is equipped with two powertrain options: a 1.0T SIDI direct-injection turbocharged engine paired with a 6-speed DSS intelligent transmission, and a 1.3T SIDI direct-injection turbocharged engine paired with a CVT intelligent continuously variable transmission. The maximum power outputs of these two engines are 92kW and 121kW, respectively.
I’ve always enjoyed tinkering with small part replacements, and changing the rear wiper on the Buick Encore is actually super easy! First, gently lift the wiper arm and locate the square button at the joint—press and hold it firmly. Then, you can slide the entire wiper blade off. When buying a new wiper, make sure it’s a universal U-hook type, and the 12-inch size is the right fit. For installation, just align the blade with the arm’s slot and push it in until you hear a ‘click.’ After replacing, remember to spray some windshield washer fluid to test the swing and wipe off any tree sap or dust on the rear window. I replace mine every six months or so—online wiper blades cost just over 20 yuan, saving me dozens compared to dealership prices. In winter, pay extra attention to the rubber strip’s flexibility; if frozen stiff, it might not install properly.
