How to Replace the Rear Wiper?

1 Answers
MacBrody
07/29/25 4:59pm
Specific steps for rear wiper replacement: 1. Remove the wiper blade, open the hood, and unscrew the fixing screws on the cover plate. 2. Bend down the hood seal, lift the hood, disconnect the spray pipe interface, and remove the cover plate. 3. Unscrew the screws under the cover plate and take off the inner plastic panel. 4. Disconnect the motor plug, unscrew the screws on both sides of the linkage rod, and then pull it out. 5. Remove the motor from the old linkage rod, install it on the new linkage rod, then insert the assembly back into the rubber hole of the linkage rod, tighten the screws, plug in the motor connector, and restore the seal and cover plate.
Was this review help?
6
4
Share
More Forum Discussions

How often should the fuel filter of Audi Q5 be replaced

Audi Q5 fuel filter should be replaced after driving 40,000KM or 42 months, whichever comes first. If not replaced in time, it will not be able to filter impurities and other functions. Over time, it will cause insufficient fuel supply and insufficient power of the car engine. If the filter is found to be very dirty before reaching the above mileage, it also needs to be replaced. It should be noted that when replacing the fuel filter, the car's engine oil, oil filter, and air filter should also be replaced. After installation, it is necessary to develop the habit of checking the sealing of the interface to avoid oil leakage. The fuel filter is referred to as the fuel filter. There are carburetor type and electronic injection type fuel filters. For gasoline engines using carburetors, the fuel filter is located on the inlet side of the fuel pump, with low working pressure, and generally uses a nylon shell. For electronic injection engines, the fuel filter is located on the outlet side of the fuel pump, with high working pressure, and usually uses a metal shell. The filter element of the fuel filter mostly uses filter paper, and some use nylon cloth or polymer materials. The main function of the fuel filter is to filter impurities in gasoline. If the fuel filter is too dirty or blocked. In-line filter paper fuel filter: Inside this type of fuel filter, folded filter paper is connected to both ends of the plastic or metal filter. After the dirty oil enters, it passes through layers of filter paper from the outer wall of the filter to the center, and clean fuel flows out.
17
0
Share

How Often Should a New Car Be Started If Not Driven?

A new car generally needs to be started once a week to ensure the proper functioning of various fluids in the engine and the car battery. If a car is left unused for an extended period, it can negatively impact various components and performance. 1. Check if the battery is depleted A car battery discharges automatically, and if the vehicle remains idle for a long time, the battery may lose charge. Additionally, some electrical components in the car continue to consume battery power even when the vehicle is off, leading to battery depletion. Before driving, always check the battery charge to avoid being unable to start the car due to a dead battery. Tip: If the car is not driven for an extended period, it's best to start it once a week to recharge the battery. 2. Check if the tires are underinflated or if the rims are deformed After prolonged parking, inspect the tires for any air leaks before driving again. If the tire pressure is low, inflate them promptly. Additionally, prolonged parking can cause deformation in the tires and rims on the side bearing concentrated weight, leading to body vibrations, tire blowouts, or other issues while driving. Therefore, always check the tires and rims before driving. 3. Inspect the fuel tank level Whether restarting the car after prolonged parking or during daily use, always check the fuel tank level before driving to avoid running out of fuel mid-journey. Additionally, drivers should inspect all vehicle fluids, including engine oil, brake fluid, and coolant, as they have a 'shelf life.' Expired fluids may pose safety risks.
9
4
Share

What Does the Yellow Engine Symbol Mean?

When the yellow engine indicator light comes on, it indicates a fault in the engine. Relevant details are as follows: 1. Common reasons for the yellow light to illuminate include: a dirty throttle body, poor fuel quality, a faulty oxygen sensor, a clogged catalytic converter, and other typical issues. The impact on vehicle safety can vary, so the owner should promptly have the engine system inspected. 2. Reasons for the engine fault light to illuminate: Poor or substandard gasoline quality. This usually occurs when low-quality fuel is added at an unregulated gas station, leading to incomplete combustion of the air-fuel mixture during engine operation and triggering the engine fault light. While this does not affect driving safety, it may cause some degree of harm to the engine.
9
4
Share

How high is the Corolla's exhaust pipe from the ground?

The Corolla's exhaust pipe is 16 centimeters high from the ground. The Toyota Corolla has a minimum ground clearance of 145 millimeters when unloaded and 105 millimeters when fully loaded. The Toyota Corolla is a classic model under the Toyota brand, with dimensions of 4540 millimeters in length, 1760 millimeters in width, and 1490 millimeters in height, and a wheelbase of 2700 millimeters. The Corolla's minimum ground clearance is 145mm, which refers to the distance between the lowest point of the chassis and the level ground when the car is fully loaded (with the maximum allowable load). The Corolla, formerly known as the Corona, is a Toyota brand that uses Michelin 215/45R17 tires, TRD Sportivo high-performance shock absorbers, and TRD TF4 17-inch sport rims to ensure excellent sports performance. The Corolla measures 4635mm in length, 1780mm in width, and 1455mm in height, with a wheelbase of 2700mm, and is equipped with a CVT transmission, reaching a top speed of 180 kilometers per hour. The exterior of the Toyota Corolla is luxurious and grand, with a strong sense of hierarchy in the front, chrome trim decoration, and a large area that makes the front appear wide. The lens headlights feature daytime running lights, giving the entire front a spirited look. Inside, the air vents on both sides of the Corolla's dashboard have changed from the current polygonal design to a circular one. The chrome trim on the dashboard differs slightly in shape from the current model, and the layout of the trim and buttons around the gear shift has also undergone some changes.
4
1
Share

What Causes the Brakes to Suddenly Become Hard and Unable to Start?

The reasons why the brakes suddenly become hard and unable to start are as follows: 1. The brakes were pressed before the engine was turned off. The car's braking system works best when the engine is running, and the brake booster is the key component that amplifies the force applied to the brake pedal. When the engine is off, the brake booster stops functioning, and typically, pressing the brake pedal three times will deplete its remaining vacuum force. 2. The car's brake booster is leaking or malfunctioning. If you haven't pressed the brake pedal after turning off the car, or if you notice that the brake pedal is hard to press while driving, it is likely due to a faulty brake booster.
7
4
Share

Does Parking with Air Conditioning On Affect New Energy Vehicles?

Parking with the air conditioning on does have an impact on new energy vehicles. In the long run, it can easily damage the engine and is also quite costly. Essentially, the air conditioning system in new energy vehicles, similar to ordinary household air conditioners in China, operates on the principle of a heat pump, regulating the interior air temperature through changes in refrigerant state and the conversion of latent and sensible heat. New energy vehicles can be categorized into the following types: 1. Pure Electric Vehicles (BEVs): These rely solely on power batteries and drive motors for propulsion. Mainstream power batteries are primarily divided into lithium iron phosphate batteries and ternary lithium batteries, with the former being earlier in development and offering better safety, while the latter has higher energy density. 2. Plug-in Hybrid Electric Vehicles (PHEVs): These are equipped with an internal combustion engine and several electric motors, with the primary power source coming from the internal combustion engine and the electric motors assisting in propulsion. They feature larger battery capacities than mild hybrid vehicles (HEVs), enabling long-distance travel in pure electric mode. 3. Range-extended Hybrid Electric Vehicles (EREVs): These are primarily driven by electric motors, with the engine serving to charge the power battery. Energy can be replenished through charging or refueling, but the sole driving source is always the electric motor, allowing the vehicle to deliver full performance in pure electric mode. 4. Fuel Cell Electric Vehicles (FCEVs): These utilize electrical energy generated from electrochemical reactions in fuel cells, where fuels like hydrogen and oxygen from the air react under the influence of a catalyst, serving as the power source for propulsion.
20
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.