How to Replace the Oil Filter on a Verna?
4 Answers
The steps to replace the oil filter on a Verna are as follows: 1. Start the engine and let it reach operating temperature. Use a jack to lift the vehicle, engage the handbrake, and secure the front wheels with wheel chocks. 2. Drain the oil. Locate the oil drain plug underneath the vehicle, unscrew it to allow the oil to flow out. Observe the oil color - normal oil should be translucent; if it appears black, it should be replaced promptly. 3. Remove the oil filter. When the oil flow slows down, unscrew the oil filter for secondary drainage. Removing the filter can be challenging and requires a specialized filter wrench. Allow all residual oil in the compartment to drain completely. 4. After complete drainage, install the new oil filter using the filter wrench and tighten it. Then tighten the drain plug and lower the vehicle. 5. Open the new oil filter package. Apply a moderate amount of new oil on the sealing ring. Wipe clean the mating surface of the filter housing with a clean cloth. Install the new filter and tighten it to proper torque using an oil filter wrench. Clean the exterior and mating surface of the new filter. 6. Reinstall the drain plug, lower the vehicle, and refill with new oil. Check the oil level. Start the engine and let it run at idle and medium speed for a while, meanwhile checking for any oil leaks around the filter. The job is complete when everything functions normally.
When I used to drive a Verna, changing the oil filter myself was quite simple. Prepare the tools: a new filter, gloves, a wrench, an oil pan, and the right oil for the Verna model. First, park the car on level ground, engage the handbrake, and it’s safer to use a jack to lift the front wheels. Crawl under the car and locate the filter position below the engine. Loosen the old filter to let the oil drain into the pan to avoid making a mess. After cleaning the dust from the contact surface, hand-tighten the new filter—don’t over-tighten it. When adding new oil, check the dipstick to ensure the level is just right. The first time I did it, I accidentally spilled oil, but later I learned that warming up the car makes the oil flow more easily. Regular changes can extend the engine’s lifespan, but if you’re not confident, just visit a repair shop to avoid headaches. Remember to dispose of the old oil properly—environmental protection comes first.
As a Verna owner, I found changing the oil filter myself isn't complicated. Started with online tutorials, just needed a new filter and basic tools. Crawled under the car to locate the filter, unscrewed the old one, and installed the new one easily. Remember to wear gloves to avoid oil stains and ensure correct tool size to prevent part damage. After completion, add new oil and check for leaks - job done. This DIY task saves money and relieves stress, feels rewarding doing monthly car maintenance. Also, choosing OEM filters ensures better compatibility, avoiding potential failures from off-brand products. More hands-on experience helps understand car structure, but don't rush to finish in one day. If stuck, calling friends for advice ensures safety and peace of mind.
I've driven for many years and replaced quite a few oil filters for the Verna. Simple steps: Prepare tools, new filter, and gloves. Locate the filter position under the engine, unscrew the old one and remove it, place an oil drain pan, then clean the contact surface. Install the new filter by hand-tightening, add an appropriate amount of oil, check for no leaks, and test start to ensure everything is normal. Be careful not to overtighten the tools to avoid thread damage. Regularly changing the filter extends engine life and keeps the oil system clean.
