How to Replace the License Plate Light on Roewe i6?
3 Answers
When replacing the license plate light on the Roewe i6, start by removing the license plate light. There are plastic clips on both sides of the license plate light cover; simply pry them apart to remove it. The license plate light is used to illuminate the license plate at night or in low-light conditions, and it is turned on together with the parking lights. According to regulations, all vehicles must have their rear license plate lights on when driving at night. The steps to replace the license plate light on the Roewe i6 are as follows: 1. Locate the license plate light position; use a flat-head screwdriver to pry open the clip and remove it. 2. The license plate light bulb is inside; twist the rear connection clockwise to remove it. 3. The license plate light is similar to the reading light and parking lights; simply pull it out. 4. Replace it with a new LED bulb.
Hey, I'm a long-time owner of a Roewe i6, and changing the license plate light by myself is a piece of cake! First, turn off the engine and power—safety first. Locate the small light cover above the rear license plate, usually secured with a Phillips screwdriver or gently pry open the clips. Be careful not to use too much force to avoid breaking the plastic clips. Remove the old bulb, most likely a T10 model, and replace it with a new LED light—cheap and durable. Insert the new bulb, cover it, and test the switch to see if it lights up. Last time, I finished in 5 minutes and saved 50 bucks in labor. Remember to wear gloves to prevent cuts when changing the light, and always test the brightness at night to avoid fines for an unclear license plate. Small tasks like this are worth doing yourself—don’t be lazy! Total word count: 165 words.
Changing the license plate light? I always remind myself to operate safely. Wait until the car is powered off after turning off the engine to avoid the risk of electric shock. For the Roewe i6, the rear license plate light is usually located in the plastic cover above the license plate, and opening the trunk might provide a better view. Use tools to slowly remove screws or clips, avoiding haste to prevent damage to components. For the new bulb, use the original T10 model, with LED options being brighter. Handle the bulb gently during replacement to ensure good contact, and always test the light function after reassembling the cover. If the light frequently fails, there might be a wiring issue that needs checking. During regular maintenance, pay attention to the light cover to prevent water ingress, and avoid high-pressure washing when cleaning the car. Doing it yourself saves money and hassle, but safety is paramount—driving at night without a functioning light can lead to fines or accidents! Total word count: 155 words.
