How to Replace the Key Battery for Trumpchi GS4?

[VanViolet]

The method to replace the key battery for Trumpchi GS4: Along the gap on the side of the car key, use your fingernail to pry open the buckle or gently lever it open with a flat-head screwdriver, then remove the battery for replacement. Below is some extended information about the Trumpchi GS4: 1. Exterior: The front grille of the Trumpchi GS4 adopts a two-tiered design, with the upper grille featuring horizontal silver chrome trim that connects seamlessly with the headlight assemblies on both sides. 2. Side Profile: The new Trumpchi GS4 comes with roof rails, and the character line along the body is sharp and dynamic, complemented by sporty wheel designs. 3. Rear Design: The rear of the Trumpchi GS4 follows contemporary trends, with a full-width taillight assembly accented by silver chrome trim. The lower rear bumper also incorporates silver chrome decorations, echoing the front design. 4. Powertrain: It is equipped with a 1.5T turbocharged engine, delivering a maximum output of 124KW and a peak torque of 265 Nm. The transmission options include a 6-speed manual gearbox and Aisin's third-generation 6-speed automatic transmission, both compliant with the China VI emission standards.

[SanGideon]

I usually enjoy tinkering with small household items, so changing the battery for my Trumpchi GS4 key is quite simple for me. There's a small gap on the side of the key, and you can gently pry open the case using a coin or a small screwdriver. Inside, you'll find a round CR2032 battery—just remember to check whether the positive side should face up or down (usually marked with a '+' sign). After removing the old battery, simply press the new one in place, and you're done. I recommend keeping a spare battery in your car to avoid any inconvenience if the key suddenly runs out of power next time. Be gentle during the whole process to avoid scratching the key surface. After replacing the battery, press a button to test if the remote function is restored. Avoid placing the key in high-temperature areas to extend the battery life. Doing it yourself saves money and effort, and you don’t even need to visit a repair shop.

[MacStella]

As an electronics enthusiast, I've replaced the key battery for my Trumpchi GS4 several times. The key design features clips, allowing the top cover to be gently pried open from the edge with a small plastic pry tool to access the battery. Inside, it uses a CR2032 coin cell battery, with the positive pole typically facing the circuit board. Before removing the old battery, use a multimeter to check the voltage; if it's below 2.5V, it's out of power. When installing the new battery, ensure correct polarity to avoid short circuits. Test the remote control range immediately after replacement to confirm it's restored. I also recommend checking the battery condition annually, as the contacts may oxidize over time—cleaning them before replacement is safer. The whole process takes just a few minutes and is quite convenient.

[McEmmett]

My Trumpchi GS4 key fob ran out of battery last time, and I replaced the battery myself. The back of the key fob splits in half, just gently pry one side open with a coin. Inside there's a small round CR2032 battery. Take out the old one, put the new battery in with the positive side facing up, close the cover and test the remote buttons. It's done quickly without much difficulty. Keeping spare batteries in the car is a good habit.