How to Replace the Key Battery for the New Mercedes-Benz ML350?

1 Answers
Bill
07/29/25 7:39pm
The method to replace the key battery for the new Mercedes-Benz ML350 is as follows: 1. Push the sliding latch on the key upwards to remove the mechanical key; 2. Use the mechanical key to pry open the outer shell of the key; 3. Remove the old battery from the key and replace it with a new one. Taking the 2015 Mercedes-Benz ML350 as an example, it is a 5-door, 5-seat SUV with body dimensions of: length 4844 mm, width 1926 mm, height 1796 mm, and a wheelbase of 2915 mm. The 2015 Mercedes-Benz ML350 is equipped with a 3.0T turbocharged engine, delivering a maximum horsepower of 258 hp, a maximum power of 190 kW, and a maximum power speed of 3600 rpm.
Was this review help?
15
5
Share
More Forum Discussions

What Causes Cracks in the Car Windshield?

Car windshield cracks are caused by significant temperature differences between the interior and exterior or by human factors and external vibrations. Below are specific details about the windshield: Value Retention Note: The car windshield is a vulnerable component. When reselling the vehicle, it may depreciate slightly more than before replacement, but the overall impact is not significant. However, it is important to ensure proper windshield replacement. Improper installation can pose safety hazards and negatively affect the car's value retention. Effects of Improper Installation: If the windshield is not installed correctly, the sealant on both sides may not adhere tightly to the glass, which can lead to issues. For example, during high-speed driving, wind may enter through gaps between the windshield and the car body, increasing interior noise. Additionally, when driving on bumpy roads, a noticeable rattling or impact sound may be heard from the front of the car.
12
3
Share

What gear should be used for a U-turn in a manual transmission car?

U-turns should be performed in first gear. Relevant information is as follows: Advantages of using first gear for U-turns: First gear is less likely to stall. During the U-turn process, once the clutch is fully engaged, you can release the clutch, throttle, and brake completely, focusing all attention on steering. Since U-turns require consideration of oncoming traffic from both directions, using first gear ensures sufficient time to react. Situations where first gear is used: First gear is also required when starting the vehicle and when the vehicle speed is below 10 km/h, otherwise it can easily damage the vehicle's clutch plates.
15
3
Share

Can I add engine oil right after turning off the car?

You can add engine oil right after turning off the car because the oil flows better when the engine is warm, making it easier to add. Here are 4 key points to note when adding engine oil: 1. Choose oil based on the engine's requirements: Do not use high-grade oil in a low-performance engine or low-grade oil in a high-performance engine. Always select oil that matches the engine specifications. 2. Opt for multi-grade oil, which offers advantages like fuel efficiency and longer service life, providing better engine protection. 3. The oil level should be slightly below the mark on the dipstick—do not overfill. Excess oil increases crankshaft resistance, reduces engine power output, and may even enter the combustion chamber, leading to oil burning, blue smoke emissions, and increased fuel consumption. 4. Select oil viscosity based on engine condition and seasonal temperature: Use lower-viscosity oil if the engine is in good condition and the temperature is low; choose higher-viscosity oil if the engine is severely worn and the temperature is high.
6
4
Share

How to Replace the Air Filter Element on a Peugeot 307?

The air filter element of the Peugeot 307 is located in the engine compartment. Below are the steps to replace the 307 air filter element: 1. Open the car's engine hood, loosen the screw of the brake fluid reservoir, and then remove the intake pipe head. 2. After removing the surface cover, you will see the air filter box. At this point, unscrew the screws of the air filter box. 3. Loosen the fixing screws at the interface between the air filter box and the throttle. 4. Remove the connecting hose, then push the air filter box to the right while lifting it, allowing the air filter box to be taken out. 5. After removing the air filter box, unscrew the screws of the air filter element, and then replace it with a new one. 6. Once the new air filter element is installed, reassemble the surface cover of the air filter box in the reverse order of disassembly. The entire process of replacing the Peugeot 307 air filter element is now complete.
7
3
Share

Is the Xidesheng RX200 a Pseudo Road Bike?

Xidesheng's RX200 is not a pseudo road bike. Positioning: The Xidesheng RX200 is positioned as an intermediate sports bike in the road bike category, featuring a relatively high cost-performance ratio. Its frame is made of aluminum alloy, with a carbon fiber front fork, weighing around 11KG. Advantages and Disadvantages: The RX200 shifts gears quickly but has poor short-distance acceleration. A drawback is that it cannot lean too low in corners, while its advantage lies in the handlebars—their feel is unmatched by bikes in the same price range. The RX is suitable for medium to short distances, with excellent shock absorption from the carbon front fork. However, its low braking performance makes it unsuitable for emergency stops, as applying too much force can cause the wheels to lock up.
10
3
Share

What to Do When the Car Always Drifts to the Right?

The solution to the car always drifting to the right is: Hold the steering wheel steady and straight: When the steering wheel is already straightened, keeping it flat and unmoved will allow the car to drive straight. During driving, the car may slightly deviate from the straight line, at which point the steering wheel should be turned slightly in the opposite direction, avoiding large turns. Additionally, hold the steering wheel steady to prevent the car from taking an "S" shaped path due to nervous hand tremors. Find suitable reference points while driving: New drivers can learn to find appropriate reference points on the road to help maintain straight-line driving. Drivers can refer to the center line, roadside line, or large trees along the road or roadside. Look far ahead: Many novice drivers tend to drift when driving on wide roads. This is because the large space and broad field of vision can weaken the reference effect of the roadside and markings. In such cases, drivers should look far ahead, making it easier to detect if the car is drifting.
8
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.