How to Replace the Key Battery for Geely Vision X6?

[DeXavier]

To replace the key battery for Geely Vision X6, follow these steps: 1. Pull out the mechanical key; 2. Use a small screwdriver with its tip wrapped in cloth to pry open the key along the groove of the mechanical key; 3. Remove the old battery with your fingernail and replace it with a new one; 4. Finally, snap the key back together in its original position. The Geely Vision X6 is a compact 5-door, 5-seat SUV with body dimensions of 4546mm in length, 1834mm in width, and 1715mm in height, with a wheelbase of 2661mm. It is equipped with a 1.4T turbocharged engine and a 6-speed manual transmission, delivering a maximum power of 104 kW and a maximum torque of 235 Nm.

[DiCharlotte]

I previously helped a friend replace the battery in their Geely Vision X6 key fob, and it was actually quite simple. First, gather the necessary tools, such as a small flathead screwdriver or a thin coin, along with a new CR2032 battery, which can usually be found at supermarkets or electronics stores. There's a small gap on the back cover of the key fob—use your fingers or a tool to gently pry it open, being careful not to apply too much force to avoid cracking the casing. Once opened, you'll see the old battery in its slot; remember the orientation—positive side facing up. Remove the old battery, insert the new one, and ensure it's securely in place. Then, close the cover and press the key buttons a few times to test if the car lights respond normally. If the key fob stops working after replacement, the contact points might be dirty—clean the circuit board with a cotton swab dipped in alcohol. The whole process takes about two to three minutes. I recommend replacing the battery every two years and keeping a spare in the car for emergencies.

[Harrison]

I drive a Geely Vision X6 and replaced its battery last year. My experience tells me not to waste money at repair shops. The key is cleverly designed with a slit on the back—you can simply use your fingernail or a thin string to pry open the cover. The button battery inside is a CR2032, which is inexpensive and can also be purchased online. When replacing the battery, make sure to align it correctly with the positive side facing outward; otherwise, it won’t work. After installation, test the start button or unlock key to ensure responsive performance. I once encountered key failure and found it was due to dust in the battery compartment—a simple cleaning fixed it. The battery typically lasts about two years, depending on usage frequency; frequent unlocking during peak times drains it faster. I recommend owners avoid exposing the key to water or heavy drops to extend battery durability.

[Ronan]

Replacing the battery in the Vision X6 key is very simple: Use a small tool to pry open the key's back cover, remove the old CR2032 battery, and replace it with a new one. The key is to apply force from the edge to avoid damaging the clips, and ensure the new battery is placed in the correct orientation. Test the functionality; if it doesn't work, adjust the position or try a new battery. The whole process is quick, and doing it yourself saves money and is convenient.