How to Replace the Key Battery for a Magotan?
3 Answers
To replace the key battery for a Magotan, follow these steps: 1. Eject the mechanical key from the remote key, then insert a flat-head screwdriver about 12mm into the guide piece on the outer side of the mechanical key in the direction of the arrow. 2. Turn the screwdriver clockwise until the cover pops up. Push the battery compartment cover in the direction of the arrow and remove it. Take out the button battery from the battery compartment, place a new button battery, and then press it into the battery compartment against the direction of the arrow. 3. Press the three buttons: "Close," "Open Trunk," and "Open" to confirm that the small light flashes, indicating the battery is installed correctly.
Last time I changed the battery for my Magotan's key, it was super easy, just like doing a little DIY project. When the key ran out of power and the remote stopped working, I first found a plastic pry tool or a small screwdriver and gently inserted it into the gap on the side of the key where there's a small opening. With a little force, the shell popped open. Inside was a flat coin battery labeled CR2032—make sure not to get the wrong model or it won't fit. I used my fingernail to pry out the old battery and noticed the contacts were a bit dirty, so I cleaned them with a tissue before placing the new battery in, positive side up. After closing the lid, I heard a click indicating it was locked. Finally, I tested the remote function in the yard, and it worked fine again. The whole process took just two minutes, and the battery cost me five yuan at a convenience store—saving me dozens of yuan compared to going to the 4S shop. Remember to be gentle and avoid using too much force to prevent damaging the internal circuit board or springs; the key shell is fragile and can't withstand rough prying. After changing it, avoid prolonged exposure to water or high temperatures—the battery should last a year or two without issues. Also, try not to swing the key around too much to reduce bumps and knocks in daily use.
Replacing the Magotan key battery requires steady hands and sharp eyes. Find a flat-head plastic tool or a small flat screwdriver. There is usually a gap on the side of the key. Align and pry open the casing. The internal structure is simple, with the battery slot located in the middle. Remove the old CR2032 battery. Ensure the new battery matches the model and size, and install it with the positive mark facing up and the negative side down. Gently press it into the slot, avoiding misalignment of the contacts, as poor contact may cause subsequent remote control failure. Close the cover and ensure the clips are securely in place. Before testing, keep away from metal objects to prevent electrostatic interference. Common mistakes include using the wrong tool and scratching the key or installing the battery in the wrong direction. Prevention methods include checking online for reference images beforehand. Low battery power in the key usually triggers a warning light or slow remote response. Regular checks can prevent sudden malfunctions. Perform the operation in a clean, dry area, avoiding humid environments to prevent rusting of components. After completion, recycle the old battery responsibly and avoid littering.
