How to Replace the Headlight Bulb on a Honda Fit?
3 Answers
The method to replace the headlight bulb on a Honda Fit is: 1. Open the engine hood and locate the bulb to be replaced at the front of the vehicle; 2. Unscrew the dust cover and disconnect the power supply; 3. Then you will see the bulb is held by a spring clip, press the clip and slide it sideways to remove the old bulb; 4. Install the new bulb, then reattach the spring clip and dust cover. The Honda Fit is a compact 5-door, 5-seat hatchback with body dimensions of: length 4109mm, width 1694mm, height 1537mm, and a wheelbase of 2530mm. It is equipped with a 1.5L engine and a CVT transmission, delivering a maximum power of 96 kW and a maximum torque of 155 Nm.
I changed the Fit's headlight bulbs three times before getting the hang of it. First, make sure the engine is off and cooled down, then open the hood to locate the headlight position. Twist the dust cover counterclockwise to remove it, and you'll see the bulb socket. Press the spring clip and gently pull out the old bulb—remember, never touch the glass of the new bulb with your fingers! Align the metal base with the slot and push it in until you hear a click, indicating it's properly seated. When reattaching the dust cover, tighten it to prevent water ingress. Finally, start the engine and test the lights. Doing it yourself can save you two hundred bucks, but if you're clumsy, you might break the clip, which would be counterproductive.
Last time I replaced the headlight bulb on my Fit, it took me half an hour. The steps are actually quite straightforward. First, let the car cool down for half an hour, then open the hood and locate the rubber cover at the back of the headlight. Twist it counterclockwise to remove it. Inside, the bulb is held by a spring clip—just press it with your thumb to remove the old bulb. When installing the new bulb, hold it by the base and never touch the glass part, or it will burn out quickly. You'll feel resistance when pushing it into the socket. A bit of finesse is needed to snap the spring clip back into place. After reinstalling the dust cover, make sure to check the seal to avoid water leakage during rain. The most crucial part of the whole process is disconnecting the power to prevent short-circuit risks.
