How to Replace the Headlight Bulb of the Buick Excelle?

1 Answers
BethanyDella
07/30/25 1:18am
To replace the headlight bulb of the Buick Excelle, follow these steps: Open the engine hood, locate the headlight bulb, and rotate the bulb cover counterclockwise. Then, remove the bulb socket to directly replace the bulb. In the Excelle, the outer part of the headlight is the position light, the middle is the low beam, and the inner part is the high beam. The Buick Excelle is a compact car under the Buick brand, with body dimensions of 4609mm in length, 1798mm in width, and 1486mm in height, with a wheelbase of 2640mm. The vehicle is equipped with two engines: a 1.0-liter turbocharged engine and a 1.3-liter turbocharged engine. For suspension, it features a front MacPherson strut independent suspension and a rear multi-link independent suspension.
Was this review help?
5
1
Share
More Forum Discussions

Where is the battery located in the 2018 BMW X2?

The battery of the 2018 BMW X2 is installed under the trunk. This placement avoids the risk of explosion caused by oil and electricity mixing in the event of a collision if it were installed in the engine compartment. BMW X2 Jump-Starting Method: The positive terminal of the battery is marked with a + symbol, and the negative terminal is marked with a -. Connect the positive and negative jumper cables to the corresponding positive and negative terminals of the battery. (This operation should be performed with both vehicles turned off.) Once the discharged vehicle is successfully started, remove the jumper cables and let the engine run for about 20 minutes to ensure the battery stores some charge. Battery Usage Precautions: Always keep the battery clean and dry. Ensure the vent holes are unobstructed. If oxides appear on the plates or terminals, clean them and apply a small amount of grease to prevent corrosion.
16
1
Share

What is the top speed of a Jeep?

Jeep's top speed is 100 km/h. Introduction to Jeep: Jeep is an American automobile brand, owned by the world's second-largest car manufacturer, Daimler-Chrysler. Jeep is a mid-range car, not too expensive but not too cheap either. It's a low-key choice with high cost-effectiveness, strong operability, and stability. However, the models are relatively large, making them more suitable for drivers of certain age groups. Jeep's vehicle lineup: Includes models like the Grand Cherokee, Wrangler, Compass, Cherokee, Renegade, and Commander. Among them, the Compass is an SUV with an on-demand four-wheel-drive system, while the Wrangler is an off-road vehicle with a part-time four-wheel-drive system.
6
3
Share

Under what circumstances does the right exhaust of the BMW X5 open?

The right exhaust of the BMW X5 automatically opens when the engine speed is high. Function of the exhaust system: It mainly ensures that the water and exhaust gases produced after fuel combustion can be discharged, providing favorable conditions for the next combustion. The BMW X5's exhaust system uses a variable valve, so when the engine speed is relatively low, the valve closes, allowing the airflow to pass through a smaller pipe diameter and be discharged through a single pipe. Introduction to the exhaust pipe valve: The car's exhaust system cannot blindly pursue smoothness because backpressure is related to the engine's low-speed torque, which is the torque range most commonly used in daily driving. Therefore, the exhaust system must have corresponding devices to ensure backpressure at low speeds, and this is where the backpressure muffler comes into play.
7
5
Share

What does Honda SCS short circuit mean?

The meaning of Honda SCS short circuit is that the circuit needs to be checked. Composition of SCS: The SCS type electronic truck scale is a digitally displayed electronic weighing instrument. The SCS series electronic platform scale mainly consists of a weighing platform, load cells and connectors, junction box, weighing display, etc. It includes: ABS - Anti-lock Braking System, TCS - Traction Control System, CBC - Cornering Brake Control, MSR - Engine Drag Torque Control, EBD - Electronic Brakeforce Distribution, VSC - Vehicle Stability Control, etc. Working principle of SCS: The electronic truck scale uses the strain gauge measurement principle for weighing. Strain gauges are attached to the elastic body of the load cell to form a Wheatstone bridge. When there is no load, the bridge is in a balanced state with zero output. When the elastic body bears a load, each strain gauge generates strain proportional to the load, and the external load can be measured from the output voltage.
11
2
Share

What does dispclock mean on the Teana car?

Dispclock on the Teana car is the head-up display activation button. When pressed, a transparent projection display device will appear in front of the vehicle's instrument panel. The function of the head-up display: The head-up display, abbreviated as HUD and also known as the heads-up display system, is a driver-centered, blind-operation, multi-functional instrument panel. Its purpose is to project important driving information such as speed and navigation onto the windshield in front of the driver, allowing the driver to view crucial driving information like speed and navigation without having to lower or turn their head. Classification of head-up displays: Suspended HUDs are fixed on the sun visor above the car driver, resulting in the HUD information being projected onto the upper area of the windshield. Dashboard-mounted HUDs, on the other hand, are fixed on the central console in front of the driver, which means the HUD information will be projected onto the front area of the windshield.
2
2
Share

What Causes the Loud Engine Noise When Accelerating in Borui?

Borui acceleration engine noise is caused by the following reasons: Exhaust system malfunction: The symptom is a hissing sound from the engine, similar to steam or air escaping from the engine. For example, when there is a leak in the intake or exhaust pipe, the vehicle will produce a loud roaring noise as the exhaust rate increases during acceleration. Engine malfunction: If the throttle is dirty and blocked, preventing it from opening to the optimal position, it will result in poor air-fuel mixture ratio in the engine, causing noise during acceleration. When pressing the accelerator, you may notice poor acceleration, lack of power, and a hysterical sound from the engine. This is most likely to occur when the engine is hot, cold, or running low on oil. If the engine speed increases but the vehicle speed rises very slowly, this is usually a sign of clutch slippage, and the clutch kit needs to be replaced.
11
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.