How to Replace the Front Headlight Bulb of the Excelle?
3 Answers
The method to replace the front headlight bulb of the Excelle is as follows: The outermost part of the Excelle's headlight is the position light, the middle is the low beam, and the innermost is the high beam. To replace the bulb, simply open the engine hood, locate the bulb you wish to replace, rotate the lamp cover counterclockwise, and then you can remove the lamp holder and directly replace the bulb. In terms of power, the Excelle is equipped with a well-tuned 1.5L engine with a maximum power output of 113 kW, paired with a 6AT transmission. For the interior, the car's dashboard features a wraparound design, making it convenient for the driver to operate during the driving process.
I used to help my neighbor with this often. Replacing the headlight bulb on an Excelle isn't actually difficult. First, park the car, turn off the engine, and let it cool for about 10 minutes to avoid burns. Then, pop open the hood and locate the rear section of the left and right headlights. Depending on the year: older Excelle models might require removing the plastic wheel arch liner, secured with screws—just unscrew them with a Phillips screwdriver; newer models usually allow you to twist off the dust cover by hand. Wear clean gloves and avoid touching the glass part of the bulb to prevent oils from shortening its lifespan. After removing the old bulb, note the socket orientation, then insert the new bulb correctly until you hear a click. Reattach the cover and test the switch to see if it lights up. Remember to buy an original H7 bulb for proper brightness consistency, saving you from redoing the job. I always wipe the socket contacts to prevent rust after each replacement for peace of mind during rainy drives. This simple DIY task takes about 15 minutes, much easier than visiting a shop.
When I first started learning car repairs, I changed the headlight bulb on a Buick Excelle, which was quite suitable for beginners. The preparation is simple: just a screwdriver and gloves. After turning off the car, open the hood and locate the headlight assembly. The Excelle's design places it near the front of the engine compartment; in most cases, you'll need to reach in to remove the dust cover. If there's a tire side panel, gently pry it open. Slowly pull out the old bulb without bending the wires, and compare the new bulb's connector shape to ensure it's identical. When inserting the new bulb, align it correctly to avoid loosening. After installation, immediately start the car to test if the brightness is normal. If it doesn't light up, check the corresponding fuse in the fuse box to see if it's blown. When choosing a bulb, refer to the car manual for the recommended model or common types like H7. Don't cheap out on low-quality bulbs, as they can burn out easily. The whole process takes about ten minutes—just stay calm and careful, and don't rush. Making a mistake once is also a learning experience.
