How to Replace the Front Fog Light on a Changan Eado?

[VonHailey]

When opening the fog light cover, pry from the inside to the outside, applying slight force to release each clip one by one. To prevent scratching the car paint, you can wrap a thin cloth around the tool. To replace the fog light, simply unscrew the three fixing screws. Below is some relevant information about fog lights: 1. In adverse weather conditions such as fog, snow, and heavy rain, or when driving in smoke-filled environments, front fog lights must be used to illuminate the road ahead and ensure driving safety. In recent years, fog lights have often been integrated into the design of the front bumper. 2. The purpose of fog lights is to make the vehicle visible to others in conditions of reduced visibility due to weather, such as fog or rain. Therefore, the light source of fog lights needs to have strong penetration. Most vehicles use halogen fog lights, while xenon fog lights are considered a more advanced option.

[StAlina]

I recently replaced the front fog lights on my Changan Eado, and the steps were actually quite simple. Prepare a Phillips screwdriver and the corresponding H11 bulb model. First, remove the protective panel under the front bumper. Crawl under the car, and you'll see the fog light mounting bracket—just remove three screws to pull out the entire fog light assembly. Before unplugging the power connector, press the clip and then rotate the bulb socket counterclockwise to remove the old bulb. Avoid touching the glass of the new bulb directly with your hands; wrap it in a tissue when installing to prevent oil residue from affecting heat dissipation. Finally, reassemble everything in reverse order, and remember to test the lights before final reassembly to ensure they work. If you encounter a damaged clip, just buy a new bracket at the auto parts market—it only costs about ten yuan.

[DelDominic]

Replacing the fog lights mainly depends on your hands-on skills. I recommend preparing a new bulb and a plastic pry bar first, as the Changan Eado's fog lights are hidden behind the bumper grille. After turning off the engine, lift the hood and reach in from above to locate the fog light cover. Twist it counterclockwise to remove the bulb holder. Be gentle when unplugging the connector to avoid damaging the wires. Wear cotton gloves for a better grip when installing the new bulb. After tightening, test the light by turning on the power. Finally, ensure the cover is properly secured by listening for a 'click' sound when screwing it back. The whole process should take about 20 minutes, but first-timers might spend extra time locating the clips correctly.

[AnthonyFitz]

When replacing fog lights yourself, prioritize safety. First, disconnect the negative battery terminal to prevent short circuits. When crawling under the car to remove the underbody panel, use a jack stand to stabilize the vehicle securely. For the Changan Eado's front fog lights, be careful not to lose the waterproof rubber gasket. After unscrewing the lamp assembly counterclockwise, compare the connectors of the old and new bulbs to ensure compatibility. During installation, position the bulb's metal contacts facing upward; a crisp 'click' sound indicates proper seating. If one side doesn't illuminate during testing, the connector likely isn't fully inserted. Wear safety goggles throughout to protect against dust, and finally, remember to reconnect the battery cable.

[Sue]

Considering the cost, doing it yourself is the most cost-effective. You can buy H11 fog lights for just 20-30 yuan at an auto parts market, while the 4S shop quotes at least 150 yuan. When working, prepare a flashlight to illuminate the work area—the Changan Eado's fog lights are located on both sides of the grille. Be careful with the plastic expansion clips when removing the guard plate screws; use a flat-head screwdriver to pry them off slowly. After replacement, remember to check the light angle—if it's too tilted, it will affect nighttime illumination. If you find the lamp socket rusted, spraying some WD-40 lubricant can extend its lifespan. This job is much simpler than changing the engine oil, though your back might ache a bit.