How to Replace the Front Fog Light Bulb on the Eado?
2 Answers
Method for replacing the front fog light bulb on the Eado: 1. There are two fixing screws at the position below the front fog light where it is secured to the front spoiler. Remove these two screws; 2. Reach inside and use a screwdriver to unscrew the two screws fixing the fog light bracket; 3. Unplug the connector, then the fog light can be removed, and the new bulb can be installed. The Eado has dimensions of 4620mm in length, 1820mm in width, and 1490mm in height, with a wheelbase of 2660mm. The Eado is equipped with two efficient engines: a 1.6L naturally aspirated engine and a 1.5T turbocharged direct injection engine. The drive method is front-wheel drive, with an L-arm MacPherson strut front suspension and a trailing arm rear suspension.
I recently replaced the front fog light bulb of my Changan Eado because the light was too dim when driving at night with heavy fog. Here's how I did it: First, turn off the engine and disconnect the negative battery terminal to prevent short circuits—safety is the top priority. Then, open the engine hood and locate the fog light position at the bottom of the front bumper. For the Eado, you might need to remove some clips or screws on the front grille using a Phillips screwdriver, but be gentle to avoid damaging the plastic. Once opened, you'll see the bulb. Carefully pull out the old bulb, and remember not to touch the glass part with your bare fingers—the oil from your skin can shorten its lifespan, so wearing gloves is better. When installing the new bulb, make sure the model matches—usually H8 or H11, as specified in the owner's manual. After installation, test the light to ensure it works before reassembling all parts. The whole process takes about 15 minutes, saving repair costs and learning some car knowledge. The key is to check your lights regularly—don't wait until it's too late during rainy days. Bulbs are cheap, just a few bucks each online.
