How to Replace the Coolant in a Baojun 510?
2 Answers
The method for replacing the coolant in a Baojun 510 is as follows: First, allow the car to cool down, then unscrew the radiator drain valve to drain the old coolant. Clean the cooling system thoroughly. After cleaning, refill with new coolant until the liquid level is between the MAX and MIN marks. Tighten the radiator cap to complete the coolant replacement. The Baojun 510 is a compact SUV with body dimensions of 4220mm in length, 1740mm in width, and 1625mm in height, and a wheelbase of 2550mm. The Baojun 510 is equipped with a 1.5-liter naturally aspirated engine across all variants, which delivers a maximum power of 77 kW and a maximum torque of 135 Nm.
I've changed the coolant in my car a few times, and the process is pretty much the same for the Baojun 510. After parking, let the engine cool down to avoid burns. Locate the drain plug at the bottom of the radiator, use a wrench to loosen it, and place a bucket underneath to catch the old coolant, which might be dirty and corrosive. Once it's all drained, check the radiator for any rust residue. Then, tighten the plug and flush the system with clean water if the old coolant was particularly dirty. Open a new bottle of coolant and pour it into the radiator up to the standard level. Don't forget to open the air bleed valve or heater hose to release any air bubbles. Start the engine and let it run for a few minutes to circulate the coolant, then turn it off and check the level, topping up if necessary. I always use the manufacturer-recommended coolant type to ensure effective winter freeze protection. Finally, dispose of the old coolant properly by taking it to a recycling point—it's both eco-friendly and safe. The whole job is easy and cost-effective, perfect for DIY enthusiasts.
