How to Replace the Cabin Air Filter in a Camry?
3 Answers
Toyota Camry models may have two filters. Below are the replacement procedures for both filters: I. Cabin Air Filter: 1. Open the glove compartment cover and locate the fixing clips. 2. After removing the fixing mechanism, the cover can be easily taken off. 3. The cabin air filter is housed in the filter box. Simply press the clips on the filter box cover to remove it. 4. The cabin air filter can then be pulled out directly (handle gently to prevent dust dispersion). 5. The filter can be reused if not too dirty—just clean it before reinstalling. 6. Generally, the end with letters should face the correct orientation. II. External Air Filter: 1. Remove the waterproof seal at the slot by locating and releasing the clips to take off the plastic cover. 2. The external air filter will be exposed; remove the old filter. 3. Install the new filter in the correct orientation.
We change the Camry's cabin air filter by hand without any tools. Just press both sides of the glove compartment to lower it completely - I usually put a towel underneath to prevent slipping. There's a long cover inside that you can easily unclip with your fingernails. Toyota's filters with electrostatic cotton are easy to recognize, just make sure the arrow direction isn't reversed. Every time I open it, I wipe away the dust inside the filter box. You'll know the new filter is properly installed when you hear it click into place. The best time to replace it is before pollen season in summer - wouldn't that 200 yuan service fee at the dealership be better spent on ribs? Remember not to install it backwards - if your AC smells bad, there's an 80% chance the filter was put in the wrong way.
Last time I tried changing the cabin air filter in my apartment's underground garage, and as a girl, I got it done in just ten minutes. After emptying the glove compartment, I just pinched both sides inward to release it. Don't forget to unhook the small nylon cord on the right side. Then you'll see a white plastic cover - push it upward to remove. Pull out the dirty filter like you're pulling a wet wipe. Remember there's an airflow arrow on the side of the filter - just align the new one the same way as the old one before trimming the edges. I installed an activated carbon version, which really reduces tunnel odors. The dealership charges 180 yuan for this, but DIY costs only 30. Make sure to reattach the damper cord properly, or the glove box will rattle.
