How to Replace the Brake Pads of an Electronic Parking Brake?
1 Answers
Steps to replace the electronic parking brake: 1. Remove the rear wheels, connect the diagnostic tool, and lift the vehicle. 2. Turn on the ignition, release the parking brake (the rear wheels should rotate freely), and enter the test procedure. 3. Access the 53 Parking Brake System. 4. Enter 04 System Basic Settings. 5. Input channel number 007, and you can hear the sound of the rear wheel motor running for about 5 seconds. The parking brake motors of both rear wheels will retract. Then, remove the old brake pads by pressing the caliper piston. 6. Enter 04 System Basic Settings again and input 006. You can hear the sound of the rear wheel motor running for about 5 seconds. The parking brake motors of both rear wheels will extend and reset. 7. Clear the fault codes, turn off the ignition, disconnect the diagnostic tool, reinstall the wheels, and test drive the vehicle.