How to Replace the Brake Light on a Lavida?

[McBentley]

Lavida's brake lights use halogen light sources, which have limited ignition cycles and lifespan, so the brake lights should be replaced promptly. The specific steps to replace the brake light on a Lavida are as follows: 1. The rear tail light assembly is located in the trunk; first, open the trunk. 2. There is a protective pad behind the rear tail light that serves as a protective cover; then, remove the protective pad of the rear tail light. Be careful not to use excessive force when removing the protective pad. 3. After removing the protective pad, you can see the circuit assembly. Use a screwdriver to unscrew the screws on the light and locate the circuit board. 4. Remove the old bulb. 5. Install the new bulb, and the brake light replacement is complete.

[ReedRose]

Last time I changed the brake light on my Lavida myself and found it quite simple. Remember to first turn off the engine and buy the correct bulb model, such as the standard halogen W21W type, which costs around ten yuan. Have a Phillips screwdriver ready, open the trunk, and locate the tail light cover. There are two small screws at the back—slowly unscrew them and be careful not to lose them. Gently pull out the lamp holder, remove the old bulb without touching the glass part, insert the new bulb, press it firmly until you hear a click, and you're done. Reinstall the lamp holder, tighten the screws, start the car, and press the brake to confirm if the light works. The whole process takes just a few minutes, saving over a hundred yuan compared to going to a repair shop—it's very cost-effective. Usually, pay more attention to the condition of your car lights; replace them promptly if they are aging to ensure safe driving and fewer accidents. It's recommended to check all other lights every six months as well, forming a good habit.

[DeKhloe]

Replacing the brake light on a Lavida is a routine task, and I'll guide you through it: First, purchase a new bulb—make sure you get the correct model like W21W, which is easily available at auto parts stores. Park the car securely, turn off all power, and lift the trunk liner to locate the brake light housing held by two screws. Use an appropriate screwdriver to loosen them counterclockwise, then gently pull out the assembly. Remove the old bulb by twisting and pulling, insert the new bulb without bending the metal contacts, and reinstall it in place. Tighten everything, start the car, and check the light by pressing the brake pedal. Don’t overlook this safety detail—a faulty brake light could lead to a police ticket or even a rear-end collision. Learning to do it yourself saves money and keeps maintenance hassle-free.

[OViolet]

My Lavelle's brake light once went out, which was quite a hassle. While driving in the rain, a friend pointed out that the rear light wasn't working. I pulled over, bought a new bulb, and got straight to work. Opening the trunk liner, pulling off the light cover, unscrewing a bolt—the assembly came right out. Pulled out the old bulb, plugged in the new one, and in no more than five minutes, the light was back on. It felt incredibly convenient, saving money and giving me a little pride. Brake lights are crucial—they signal others to slow down. Fixing it myself cost just a few bucks, way cheaper than taking it to a shop. If you ever face a light issue, don’t panic. With the right tools and bulb, you can fix it yourself. Plus, it’s a good habit to regularly check your car lights.