How to Replace the Brake Light of a Geely Emgrand?
3 Answers
Method for replacing the brake light of a Geely Emgrand: 1. Open the trunk lid and disconnect the vehicle's power supply; 2. Remove the dust cover on the back of the taillight to access the bulb socket; 3. Identify the bulb that needs replacement, press the optional handle behind the bulb to unscrew it, and then install the new bulb; 4. Reassemble the taillight and dust cover. The dimensions of the Geely Emgrand are 4631mm in length, 1789mm in width, 1470mm in height, with a wheelbase of 2650mm. This model includes various versions such as GL, GS, and the New Emgrand, among which the EC718 and EC718RV are the first B-segment sedans and hatchbacks developed by Geely, adhering to European regulations and standards.
I've got experience changing the brake lights on a Geely Emgrand. First, open the trunk and locate the position of the taillight cover. Use a Phillips screwdriver to remove the screws on the cover - newer Emgrand models use clips, so you can just pry it open. Here's the key point: when removing the old bulb, you need to pinch the base and rotate it 90 degrees before pulling it out. Don't yank the wires forcefully. When installing the new bulb, remember not to touch the glass part with your hands - the oils from your skin can cause the filament to overheat and burn out. It's safer to install the bulb wrapped in tissue paper. Then plug it back into the socket and test if it lights up before reassembling the cover. Last time I did it myself, it took about ten minutes, but inexperienced people should check the vehicle manual as Emgrand designs vary by year. All you need are a screwdriver and the matching W16W bulb - I recommend keeping a spare bulb in the car for emergencies.
Here's a simple method for you: First, prepare a single-filament bulb with the model number W16W. Lift the trunk liner and locate the brake light cover. Older models have three screws, while newer ones simply use clips. Be gentle when removing the cover to avoid damaging the seal, otherwise it may leak during rain. To remove the bulb, press and rotate the socket before pulling it out—don't yank the wires. Before installing the new bulb, wipe the contacts with alcohol swabs to prevent poor contact and flickering. After reassembly, test the brake several times to ensure the high-mounted stop lamp and both side lights illuminate simultaneously. DIY replacement costs just 5 RMB, while a repair shop would charge 30-50 RMB. Be careful not to purchase inferior bulbs—I once bought a no-name brand that burned out within a week. Remember to turn off the car's power for safety when replacing bulbs.
