How to Replace the Battery of Peugeot 2008?
3 Answers
The method to replace the battery of Peugeot 2008 is as follows: 1. Open the engine hood and locate the battery position; 2. Remove the cable on the negative terminal of the battery and the bracket that fixes the battery; 3. Remove the positive terminal cable and take out the old battery; 4. Install the new battery, tighten the screws, and test the vehicle. The Peugeot 2008 is a compact 5-door, 5-seat SUV with body dimensions of 4312mm in length, 1785mm in width, 1545mm in height, and a wheelbase of 2612mm. It is equipped with a 1.2T turbocharged engine and a 6-speed dual-clutch transmission, delivering a maximum power of 100 kW and a maximum torque of 230 Nm.
A few days ago, I just replaced the battery for my Peugeot 2008, and the process was quite straightforward. The first step was to turn off the engine and engage the handbrake to ensure the car wouldn't move, then I wore insulated gloves for protection. The battery is usually located at the bottom right corner of the engine bay. I started by loosening the negative terminal (the black cable clamp) with a cross wrench, then removed the positive red cable clamp to prevent short-circuiting. After disconnecting, I unscrewed the mounting bracket and lifted out the old battery. The new battery must match the original car specifications. When installing it, I aligned it properly and tightened the bracket. The connection sequence is reversed: first the positive terminal, then the negative, and I tightened the clamps firmly to prevent loosening. Finally, I started the car to test it—the engine sounded normal, though the dashboard clock might reset, but it automatically adjusts after driving around for a bit. I saved on repair costs and learned something new.
DIY battery replacement can save you a lot of money, with safety and effectiveness being the key. First, confirm that the Peugeot 2008 battery is located in the lower right area of the engine compartment. After turning off the engine, engage the handbrake and wear gloves. When using a wrench to remove the battery, always disconnect the negative terminal first, then the positive, to avoid sparks from short circuits. After removing the old battery, clean the base of dust and ensure the new battery is of the same size, placed correctly, and securely fixed. Reverse the connection order: tighten the positive terminal first, then the negative, and ensure they are firmly secured without any looseness. Start the vehicle and check if the lights and dashboard are functioning normally. Sometimes, error codes or incorrect time may appear; driving for five minutes or disconnecting the power can reset the system. For daily maintenance, it's recommended to check the terminals for corrosion to extend battery life.
