How to Replace the Battery of a Tire Pressure Monitor?

1 Answers
McJack
07/25/25 9:02am
It is necessary to remove the tire and then install the sensor on the wheel hub. After installation, vehicle dynamic balancing must be performed, which is generally done at a tire shop or repair shop. For external tire pressure monitors, simply replace the sensor on the tire's valve stem. The steps are simple and can be done by yourself.
Was this review help?
11
4
Share
More Forum Discussions

What are the differences between the Mazda CX-4 Youth Edition and Vitality Edition?

The biggest difference between the Mazda CX-4 Youth Edition and Vitality Edition models lies in their configurations. The Vitality Edition adds features such as front and rear parking radar and an electric sunroof. The Mazda CX-4 is positioned as a compact SUV. Below is an introduction to the Mazda CX-4: 1. In terms of body dimensions, the Mazda CX-4 measures 4637/1855/1524mm in length, width, and height, with a wheelbase of 2700mm. 2. In terms of power, this car is equipped with 2.0L and 2.5L engines. The 2.0L engine has a maximum power of 116kw and a maximum torque of 202 Nm, while the 2.5L engine has a maximum power of 141kw and a maximum torque of 252 Nm. In terms of the transmission system, the engines are paired with a 6-speed automatic transmission.
3
2
Share

Why Doesn't the Mercedes Key Lock Button Raise the Windows When Held Down?

The reasons why the Mercedes key lock button does not raise the windows when held down are as follows: 1. The windows have not been initialized; 2. The one-touch window lift function is malfunctioning. Here is some relevant information about Mercedes-Benz cars: 1. In terms of power: The SLK roadster, which excels both inside and out, is equipped with a 4-cylinder 2.3-liter large turbocharged engine, with a maximum output of 193 horsepower. It consumes 8.2 liters of fuel per 100 kilometers, accelerates from 0 to 100 km/h in just 6 seconds, and has a top speed of 237 km/h. 2. In terms of features: The SLK is also equipped with a 5-speed electronically controlled automatic transmission, which can measure the driver's agility in using the accelerator and determine gear shifts and responses based on changes in speed, engine load, cruise control conditions, and engine temperature.
8
4
Share

How to Properly Use High Beams?

High beam usage: High beams should only be used when there are no other lighting facilities on the road and no vehicles approaching from the opposite direction. High beams are extremely bright, and their misuse can severely impair the vision of oncoming drivers, potentially leading to traffic accidents. Therefore, it is crucial to use high beams correctly. Additional guidelines include: 1. On roads without central barriers or center lines, do not use high beams when meeting an oncoming vehicle within 150 meters. 2. Avoid using high beams when meeting non-motor vehicles on narrow bridges or roads without central barriers or center lines. 3. Do not use high beams when turning at intersections controlled by traffic signals. 4. In low visibility conditions such as at night without streetlights, poor illumination, or during fog, rain, snow, or dust, refrain from using high beams when following another vehicle closely in the same direction. 5. When overtaking at night, alternate between high and low beams to alert the vehicle ahead. 6. High beams are not recommended in well-lit urban areas.
7
0
Share

What is the normal range of tire pressure?

Car tire pressure normally ranges between 230-250kpa. Cold tires and hot tires have different pressures, with hot tires being about 20kpa higher than cold tires. Standard tires have a pressure of 240kpa-250kpa, while reinforced tires have a pressure of 280kpa-290kpa. Additional information: Regularly checking tire pressure ensures safety: 1. Before driving, inspect the tire condition. Radial tires—commonly known as low-pressure tires—are normal as long as the aspect ratio is not too low; if they feel very elastic when pressed with your foot and not too soft, they are fine. 2. High-pressure tires: These refer to bias-ply tires with inner tubes. Viewed from the front, the shoulder area should not protrude, commonly referred to as "not bulging." Viewed from the side, the contact area with the ground should be similar to normal. 3. While driving, pay attention to the sound of friction between the tires and the ground, the cushioning force when driving over uneven roads, and whether the acceleration feels different from usual when pressing the gas pedal.
1
5
Share

Can the Rear Seats of the Baojun 730 Be Folded Flat?

The rear seats of the Baojun 730 can be folded flat in two ways: partial folding and full folding. On both sides of the rear seats, you can find pull straps. By pulling these straps, you can adjust the seat backrest or fold it flat directly. Full folding of the rear seats means the backrest is a single unit, allowing for more space when needed. However, when the rear seats are folded flat, they cannot accommodate passengers. Below is an introduction to the Baojun 730: 1. In terms of space, the Baojun 730 CVT version features an ergonomically optimized design with a 2+3+2 seating layout. The second and third-row seats can be folded completely flat to suit different needs, ensuring passenger comfort while providing ample and practical storage space. 2. In terms of power, the Baojun 730 CVT version is equipped with a '1.5T turbocharged engine + simulated 8-speed CVT transmission' powertrain combination. The engine has a rated power of 111kW and a maximum net torque of 250N·m.
12
4
Share

Where is the cruise control switch for the BYD Qin?

The cruise control switch for the BYD Qin is located on the left side of the steering wheel. When the vehicle is started and shifted into D gear, press the cruise control switch, and the cruise control indicator light on the instrument cluster will illuminate. When the vehicle speed exceeds the preset speed, press the set button to set the current speed as the target cruise speed, and the 'SET' indicator light on the instrument panel will illuminate, indicating that the setting is successful. The BYD Qin is a high-performance sedan under the BYD brand. The dimensions of this car are 4740 mm in length, 1770 mm in width, and 1480 mm in height, with a wheelbase of 2670 mm. In terms of exterior design, the BYD Qin features a multi-horizontal grille integrated with the headlights at the front, giving it a highly recognizable and cohesive appearance. The rear of the car still adopts an integrated tail light assembly, with a '5.9 seconds' badge on the rear, highlighting the BYD Qin's rapid acceleration capability.
15
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.