How to Replace the Battery in a Toyota Vios Remote?

1 Answers
MacGabrielle
07/30/25 1:30am
Toyota Vios remote battery replacement method is as follows: 1. Locate the button on the back of the car key to remove the mechanical key. 2. Wrap a small cloth around a screwdriver and insert it into the small hole in the middle of the mechanical key. 3. Twist the key shell to open it from both sides. 4. Remove the key cover, take out the circuit board, and replace the battery. More information about the Toyota Vios: 1. The 2021 Toyota Vios is a compact car with body dimensions: length 4435mm, width 1700mm, height 1490mm, and a wheelbase of 2550mm. 2. The 2021 Toyota Vios has a minimum ground clearance of 160mm and a body weight of 1070kg.
Was this review help?
20
1
Share
More Forum Discussions

Can Flood-Damaged Vehicles Be Insured?

Flood-damaged vehicles can be insured. Here are the relevant details: 1. Introduction to flood-damaged vehicles: Flood-damaged vehicles refer to cars that have been submerged in water and are sold through certain channels to used car markets across China. 2. Introduction to partially submerged vehicles: Partially submerged vehicles typically have water levels just above most of the wheel hubs, with the floor mats definitely submerged. However, the water does not reach the engine compartment, leaving the engine and wiring harnesses undamaged. 3. Introduction to fully submerged vehicles: Floodwaters completely submerge the entire vehicle body, including the engine and all interior equipment. Such vehicles are essentially rendered useless and should not be purchased, no matter how new they appear. Not only is the engine likely damaged from water ingress, but the wiring harnesses in the engine compartment have also been soaked, significantly increasing the risk of short circuits and potential self-ignition.
17
1
Share

Will Driving with the Handbrake On Damage the Car?

Driving with the handbrake on can damage the car. The specific hazards of driving with the handbrake engaged are as follows: 1. Increased brake wear: The most direct impact is accelerated wear on the brake discs and hardening of the brake pads due to overheating, as well as stretching of the handbrake cable. This leads to a decline in braking performance, and the burnt smell sometimes noticed by drivers originates from this. In severe cases, smoke may emerge from the rear of the vehicle. 2. Damage to brakes and tires: The faster the speed while driving with the handbrake on, the greater the wear on the braking components, and it can also cause some damage to the tires. If the handbrake is left engaged for too long, it can cause the rear wheels to lock up, leading to smoke from friction and a significant loss of braking performance.
17
1
Share

Will Installing an OBD Fuel Saver Damage the Car?

Installing an OBD fuel saver will not cause any damage to the car. An OBD fuel saver is a power and fuel optimization device (based on OBD protocol) that can adjust the vehicle according to the driver's habits, remap the car's ECU, and self-regulate. It not only enhances and optimizes the car's engine and power, giving the driver a refreshing new feel, but also improves fuel efficiency, significantly aiding in reducing the car's fuel consumption. Overall, it can save a small amount of fuel, but the effect is certainly not as much as advertised by sellers. Moreover, whether it saves fuel or not depends on the car model, as some models are completely immune to OBD fuel savers. Since modern cars are largely electronically controlled, parameters such as ignition timing, fuel injection volume, and mixture concentration in the engine are all controlled by the engine ECU's program.
13
3
Share

Where is the throttle located in a minivan?

The throttle in a minivan is positioned behind the air filter of the intake system and in front of the intake manifold. The upper part is connected to the air cleaner, while the lower part links to the engine block. The throttle serves as the throat of the car engine, connecting the air cleaner and the cylinder block. It controls the engine's air intake. When the driver presses the accelerator pedal, it doesn't directly control the fuel injection but rather adjusts the throttle's opening. There are two types of throttles: traditional cable-operated and electronic. In traditional engines, the throttle mechanism operates via a cable connected at one end to the accelerator pedal and at the other to the throttle linkage plate. Electronic throttles use a throttle position sensor to regulate the opening angle based on the engine's energy requirements, thereby adjusting the air intake. If the throttle is not cleaned regularly, carbon deposits can accumulate. How to determine if the throttle needs cleaning: Use a diagnostic tool to read the throttle's opening at idle. If it's significantly larger than when the vehicle was new, cleaning is required. Alternatively, base it on mileage—typically around 20,000 kilometers, though this varies with usage (e.g., vehicles frequently driven on dusty roads require more frequent cleaning). Another method is to remove the intake duct and inspect the throttle for carbon buildup. Throttle cleaning methods include disassembly cleaning and non-disassembly cleaning. Disassembly cleaning involves removing the entire throttle assembly and thoroughly cleaning it with a specialized cleaner. This method is more labor-intensive but ensures a thorough clean. Non-disassembly cleaning has two approaches: one involves removing the intake duct and spraying cleaner onto the throttle while the engine is running; the other involves spraying cleaner onto the throttle and wiping it, requiring two people. This method is convenient but less effective, suitable for throttles with minimal carbon buildup. Electronic throttles integrate a throttle control unit, so care must be taken during cleaning to avoid damaging the internal circuit board.
20
5
Share

What does 'Refer to the owner's manual for coolant refill' mean?

Refer to the owner's manual for coolant refill is a reminder to the vehicle owner that coolant needs to be refilled. The following is an introduction about coolant: 1. Introduction to coolant: Coolant, the full name should be antifreeze coolant. It means coolant with antifreeze function. 2. Coolant can prevent the coolant from freezing and cracking the radiator and freezing the engine cylinder block during parking in cold seasons. 2. Functions of coolant: (1) Winter antifreeze: Prevents the coolant from freezing and causing the radiator and engine block to crack after the car is parked in winter. (2) Anti-corrosion: Prevents corrosion in the cooling system. (3) Anti-scaling: Reduces the formation of scale to avoid clogging the circulation pipes and affecting the heat dissipation function of the cooling system. (4) Anti-boiling: Meets the heat dissipation and cooling needs of high-load engines.
3
1
Share

How many kilometers can a car run on a full tank of gas?

For private cars, the distance that can be covered on a full tank of gas varies significantly between different models, depending on the size of the fuel tank and the engine displacement. For example, a car with a 2.0L engine typically consumes about 10 liters of fuel per 100 kilometers, and with a fuel tank capacity of 60-70 liters, it can run approximately 600-700 kilometers. Considering factors such as load-bearing efficiency, installation space, engine displacement, and fuel consumption, most cars are designed with a fuel tank capacity that allows for about 500 kilometers of mixed driving conditions. Generally, cars with a 1.6-1.8L engine displacement have fuel tanks ranging from 40-50 liters, while those with a 2.0-2.4L displacement have tanks around 50-60 liters. For a 1.6L car, driving purely in urban areas, a full tank usually allows for 300-400 kilometers, whereas on suburban roads or highways, it can typically cover over 600-700 kilometers.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.