How to Replace the Battery in a Peugeot 408 Key?

1 Answers
Petunia
07/29/25 10:43pm
Peugeot 408 key battery replacement method is: 1. Use a small screwdriver to insert into the groove and pry open the remote control back cover; 2. Remove the remote control back cover, take out the exhausted battery and install a new one, paying attention to the positive and negative positions, then reinstall the remote control cover and reinitialize the remote control. The Peugeot 408 is a compact sedan under Dongfeng Peugeot, with a length, width, and height of 4750mm, 1820mm, and 1488mm respectively, and a wheelbase of 2730mm, equipped with a 6-speed dual-clutch transmission. The car has a top speed of 205 kilometers per hour, with front suspension using MacPherson independent suspension and rear suspension using a deformable crossbeam suspension.
Was this review help?
13
4
Share
More Forum Discussions

Can Different Grades of Gasoline Be Mixed?

Gasoline can be mixed, and here are the relevant details: Mixing gasoline is possible: For gasoline from different companies, the state has strictly standardized the main components of additives in gasoline. Even if mixed, it will not cause harm. In emergency situations, gasoline from Sinopec and PetroChina can be mixed occasionally, but from a long-term perspective, it is not recommended to mix gasoline from different oil companies. Gasoline composition: Gasoline mainly consists of C5-C12 aliphatic hydrocarbons and cycloalkanes, along with a certain amount of aromatic hydrocarbons. Gasoline has a high octane number (anti-knock combustion performance) and is classified into grades such as 89, 92, and 95 based on the octane number. Gasoline is produced by refining different gasoline components obtained from petroleum refining, including straight-run gasoline components, catalytic cracking gasoline components, and catalytic reforming gasoline components, which are then blended with high-octane components. It is primarily used as fuel for spark-ignition internal combustion engines in automobiles.
5
4
Share

What are the signs of a bad motor?

The signs of a bad motor are: 1. The car won't start, stalls at idle, sometimes it can start, and after starting, it can drive normally when accelerating; 2. Unstable idle speed, idle shaking; 3. The engine idle speed is too high; 4. The engine idle speed is too low; 5. Slow acceleration when speeding up, unable to run. The motor is used to bear the car's idle speed, its purpose is to adjust the idle speed according to the engine load at idle. The idle motor is installed on the throttle body and is controlled by the engine controller to regulate the engine idle speed. When the engine speed deviates from the idle speed, it is adjusted by the throttle valve, which controls the amount of air entering the intake manifold and is mechanically operated by the accelerator pedal cable.
10
1
Share

What engine does the jcwcountry use?

jcwcountry uses a 2.0L turbocharged engine. Taking the 2021 jcwcountry as an example, its body dimensions are: length 4310mm, width 1822mm, height 1616mm, wheelbase 2670mm, fuel tank capacity 61L, and luggage compartment capacity ranging from 450 to 1390L. The 2021 jcwcountry is equipped with a 1.5T turbocharged engine, with a maximum horsepower of 136ps, maximum power of 100kW, maximum torque of 220Nm, and is paired with a 7-speed dual-clutch transmission.
7
4
Share

Where is the tire pressure marking on the Buick Excelle XT?

The tire pressure marking on the Buick Excelle XT can be found on the side of the tire. Taking the 2010 Excelle XT as an example, it is a compact car with the following dimensions: length 4419mm, width 1814mm, height 1487mm, wheelbase 2685mm, minimum ground clearance 101mm, and a hatchback body structure. It has a fuel tank capacity of 60L and a trunk capacity of 375L. The 2010 Excelle XT features a MacPherson strut front suspension and a compound torsion beam rear suspension. It is equipped with a 1.6L naturally aspirated engine producing a maximum horsepower of 121PS, maximum power of 89kW, and maximum torque of 150Nm, paired with a 6-speed automatic transmission.
19
0
Share

What are the speed ranges for manual transmission gears?

Manual transmission gear speed ranges are as follows: 1. 1st and 2nd gears correspond to speeds of 5 to 20 kilometers per hour; 2. 3rd gear corresponds to speeds of 20 to 40 kilometers per hour; 3. 4th gear corresponds to speeds of 40 to 60 kilometers per hour; 4. 5th gear corresponds to speeds of 60 to 100 kilometers per hour. The functions of manual transmission gears are: 1. 1st gear is the starting gear, used for vehicle launch; 2. 2nd gear is the passing gear, used for navigating complex road conditions and handling difficult situations; 3. 3rd gear is the transition gear, used for low-speed urban driving; 4. 4th gear is the cruising gear, used for prolonged high-speed driving; 5. 5th gear is the high-speed gear, used for long-distance highway driving.
3
0
Share

Is the Toyota IZOA equipped with a China VI emission standard engine?

Toyota IZOA is equipped with a China VI emission standard engine. Taking the Toyota IZOA as an example, its body dimensions are: 4455mm in length, 1845mm in width, and 1565mm in height, with a wheelbase of 2640mm, a fuel tank capacity of 50 liters, and a curb weight of 1505kg. The Toyota IZOA features a MacPherson strut front suspension and an E-type multi-link rear suspension. It is powered by a 2.0L naturally aspirated engine with a maximum horsepower of 171PS, a maximum power output of 126kW, and a maximum torque of 203Nm, paired with a continuously variable transmission.
19
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.