How to Replace the Battery in a New Magotan Key Fob When It Runs Out of Power?
3 Answers
The method to replace the battery in a New Magotan key fob is as follows: 1. Remove the silver decorative piece at the bottom of the key by pushing it sideways toward the hidden button with your thumb; 2. Take off the silver decorative cover; 3. Open the rear cover of the key, pry open the back cover, remove the old battery, and replace it with a new one. The dimensions of the New Magotan are 4865mm in length, 1832mm in width, and 1471mm in height, with a wheelbase of 2871mm and a fuel tank capacity of 66L. Its engine delivers a maximum horsepower of 150Ps, a maximum power output of 110kW, a maximum torque of 250Nm, and a maximum torque speed range of 1750 to 3000rpm.
When I encountered a car key battery running out before, dealing with it was actually quite simple. The key casing is usually held together by two plastic pieces, which can be gently pried open along the edge with a small knife or coin—just avoid using too much force to prevent damaging the shell. When removing the old battery, remember its model, typically a CR2032, which can be bought cheaply at supermarkets or online. The key to installing the new battery is ensuring the positive side faces up—there’s a plus sign marking on the battery, and if placed backward, the key won’t work. After replacement, snap the casing shut and press the buttons to check if the light turns on. If the key responds sluggishly or the red light dims, it’s a warning that the battery is running low—it’s advisable to keep a spare battery in the car just in case. I regularly check mine to avoid locking troubles when driving out, saving both money and hassle. Just be careful not to pinch your fingers on the edges and use flat-headed tools to prevent scratches.
I've been driving a Volkswagen for several years, and once the key suddenly stopped working because the battery was dead. There's a small slit on the back of the key. I used my fingernail or the tip of the keychain to slowly pry open the shell, then took out the round battery and replaced it with a new one. The battery model is CR2032, which can be bought at an electronics store for a couple of dollars. When installing the new battery, make sure the positive side faces up to avoid putting it in the wrong way; otherwise, the key light won't turn on, and all your effort will be wasted. After finishing, press the shell tightly and test the buttons to confirm everything works. I always keep spare batteries in the car because the battery life is about two years. If the key can't lock the car from a distance, it's a sign that the battery needs replacing. It saves money and time—just five minutes of DIY work, and you don’t have to make a special trip to the dealership to waste money. Also, avoid exposing the key to water or high temperatures, as this can accelerate battery aging. Store it in a dry place to extend its lifespan.
