How to Replace the Battery in a Mazda Car Key?
2 Answers
The steps to replace the battery in a Mazda car key are: 1. Pull out the mechanical key inserted in the key; 2. Pry open the gap on the side of the key; 3. Open the key cover and remove the old battery for replacement. Taking the Mazda Atenza 2020 model as an example, its body dimensions are: length 4870mm, width 1840mm, height 1445mm, wheelbase 2830mm, and fuel tank capacity 56.2L. The Mazda Atenza 2020 model is equipped with a 2.0L naturally aspirated engine, with a maximum power of 116kW and a maximum torque of 202Nm, paired with a 6-speed automatic transmission.
As a hands-on DIY enthusiast, I've replaced the batteries in several Mazda car keys, and the process is quite straightforward. You'll need a small flat-head screwdriver or a specialized prying tool to gently open the key fob by locating a small gap on the back. The coin cell battery inside is typically a CR2025 model. After removing the old battery, make sure to install the new one with the positive side facing up to avoid incorrect placement. Once the casing is reassembled, test the key's functionality by pressing the buttons to see if it unlocks the doors or starts the vehicle. If the response is sluggish or nonexistent, check if the contact points are clean or if the battery is installed correctly. I usually buy a few spare batteries online for convenience, though they're also available at supermarkets. DIY replacement saves both time and money. Regularly check the battery every two years to avoid the hassle of a dead battery at a critical moment. Remember to handle the tools gently to prevent scratching the key—the entire process takes less than ten minutes.
