How to Replace the Battery in a Lae Festa Key Fob?

[StAdriana]

The method to replace the battery in a Lae Festa key fob: 1. There is a silver round button at the top of the key fob's front side, press this button; 2. With the other hand, grasp the silver part at the top and pull out the mechanical key; 3. Insert the mechanical key back halfway and turn it clockwise to separate the key fob's cover, or use a small flathead screwdriver to pry it open; 4. Once a gap appears, use your hands to split the key fob cover into two halves, one of which has a rubber pad and circuit board, remove the rubber pad; 5. Continue using a small knife or flathead screwdriver to pry open the circuit board along one side; 5. After prying open the circuit board, you will see the round coin battery inside, remove the old battery and replace it with a new one.

[StephenDella]

I've replaced the battery in my Elantra key fob several times myself – it's super simple and hassle-free. You'll need a new CR2032 coin cell battery, which you can easily find at supermarkets or drugstores for around 10 yuan. On the back of the key, there's usually a small groove. Use a small screwdriver or your fingernail to gently pry open the casing, being careful not to apply too much force to avoid damaging the plastic. When removing the old battery, note the orientation (usually the concave side faces up or the positive mark faces outward). Insert the new battery in the same orientation, then firmly snap the cover back in place until you hear a click. Finally, test the unlock button for responsiveness – typically these batteries last 1-2 years with normal use. If it still doesn't work, try cleaning the contacts as it might be a connection issue. DIYing this saves significant time and money compared to visiting the dealership, plus it's quite satisfying. Just remember to use plastic tools to avoid scratching the key.

[DallasMarie]

Replacing the battery in your Elantra key fob is quite simple. First, find a small screwdriver or a thin card. The back cover of the key usually has a notch or clip, which can be gently pried open. Remove the old battery and check its model—CR2032 is the standard type, so make sure not to buy the wrong one when purchasing a replacement. The key to installing the new battery is aligning the positive and negative terminals correctly; in most cases, the negative side should face upward when placing it into the slot. Then, close the cover firmly and test the button functions. Be careful not to touch the metal surfaces of the battery with your fingers to avoid static electricity, and avoid cracking the casing while prying it open. If the seam is dirty, cleaning it beforehand is a good idea. The whole process takes just a few minutes, and mastering this trick means you won’t panic the next time the battery runs out.

[StDawson]

I remember last time my key fob ran out of battery and gave me a scare. Actually, changing the battery is super easy. There's a seam on the back of the Elantra's key fob - just pry it open with your fingers or a small tool. Inside, you'll find a small round battery that can be gently popped out and replaced. When buying a new battery, just ask for CR2032 model, which costs just a few yuan. When putting it back, make sure the flat side faces down or follow how the old battery was positioned. Press the cover back until you hear a click, then test the key by pressing it a few times to see if the light comes on. Once it's done, you can relax. Don't be like me on my first try - shaky hands wasted one battery, haha.