How to Replace the Battery in a Kicks?
3 Answers
On the back of the smart key, there is a small switch that allows you to remove the manual key. Use a small flat-head screwdriver to insert into a gap at the opening end of the smart key and pry it open, then remove the old battery. Replace it with a new battery, and close the remote control part with the new battery installed.
Replacing the Kicks battery is something I think even beginners can handle, but safety comes first. You'll need a wrench, gloves, and a new battery. I recommend checking online for the correct model first to avoid buying the wrong one. Generally, the Kicks' battery is located at the front right of the engine compartment, easily visible once you pop the hood. When starting the replacement, remember the sequence: first, turn off the engine, disconnect the negative cable, loosen the black clamp with a wrench, and wait a minute for the system to discharge; then disconnect the positive cable, also loosening the red clamp. This prevents short circuits—I once overlooked this and nearly caused sparks. Next, remove the old battery and place the new one in, then reverse the installation order: connect the positive first, tightening the terminal; then the negative. Finally, start the car to test the new battery and check if the dashboard lights are normal. If starting is difficult, the terminals might not be tight enough, or there could be a wiring issue. For maintenance, I suggest cleaning the battery terminals every six months to extend its lifespan. A stalled car is too dangerous, so before you start, watch some tutorial videos, and if you're really unsure, it's safer to ask a mechanic.
Replacing the Kicks battery by yourself is actually quite simple, and I often do it at home. Just a regular wrench is needed, usually around 10mm in size. The battery is located under the hood, near the front of the car. The steps for replacement are straightforward: turn off the engine, park in a safe spot; first loosen the negative (black) clamp, wait a few minutes to discharge before proceeding; then loosen the positive (red) clamp; remove the old battery, clean any dirt from the base; place the new battery and secure it; first tighten the red clamp, then the black clamp. Done in one go. I also have an extra reminder: the new battery must match the specifications, otherwise, voltage instability might cause car issues. After replacement, start the car to test; dashboard lights on indicate success. Batteries generally last three to five years before aging; slow starts or dim lights are signs it's time to replace. Doing it yourself saves money and gives a sense of achievement, but don't forget to wear gloves to prevent electric shock.
