How to Replace the Battery in a Geely Vision X6 Remote Key?
2 Answers
Here is the method to replace the battery in the Vision X6 key: 1. There is a logo on the Vision X6 key, press it firmly and pull out the mechanical key. 2. Use a small screwdriver with its tip wrapped in cloth to gently pry open the car key along the groove of the mechanical key, and you will see the battery inside. 3. Use your fingernail to gently remove the old battery, replace it with a new one, and then snap the key back into place. Below are some precautions for replacing the battery in the Vision X6 key: 1. Make sure the new battery model is the same as the old one, and install the battery with the correct polarity. 2. Do not move or touch any components inside the key randomly, as this may affect the normal use of the key. 3. Keep the environment dry and avoid using wet hands to replace the battery, as water may cause unexpected rust on the battery.
I just replaced the battery in my Geely Vision X6's key fob, and it was actually quite simple. There's a small groove on the back of the key—just use a flathead screwdriver or a stiff card to gently pry open the casing. Be careful not to use too much force to avoid damaging the plastic clips. Once opened, you'll see the battery slot. The old battery removed is a CR2032—remember the polarity (usually the side marked with a "+" faces up). Before inserting the new battery, it's a good idea to check the contacts to ensure they're clean and rust-free, then press the battery firmly in place before snapping the casing back together. After replacement, immediately walk to your car and test the remote buttons to see if they unlock the doors or start the engine. If it doesn't work, the battery might be inserted backward or the casing isn't securely fastened. For regular maintenance, keep a few high-quality CR2032 batteries in your car for emergencies, saving you the hassle and expense of rushing to a 4S store last minute. The whole process takes just a few minutes—safe and cost-effective.
