How to Replace the Battery in a CS75 Car Key?
3 Answers
There are several steps to replace the battery in a CS75 key, which are as follows: 1. Use a small flat-head screwdriver or a plastic pry tool to gently pry open the remote control shell. Be careful not to damage the internal circuit during the prying process, especially in winter; it is advisable to touch metal to discharge static electricity before operation. 2. For detachable mechanical keys, the mechanical key needs to be removed first. You can use the mechanical key to pry at the gap. Once the gap is pried open, the entire cover can be opened. 3. After opening the remote key cover, you can see the battery, which can then be taken out and replaced. 4. When installing, pay attention to the positive and negative directions. After installing the battery, simply close the key cover.
I often replace the battery in my Changan CS75 car key since my car is a few years old now. There's a small notch on the back of the key fob - just gently pry it open with a flathead screwdriver or a stiff card, being careful not to use too much force to avoid cracking it. The battery is typically a CR2032 coin-type lithium cell, which you can easily find at supermarkets or online. When removing the old battery, pay attention to the positive/negative orientation - don't mix up the markings on the top side. Make sure the new battery is securely seated, then snap the cover back on firmly. Test the door unlock button - if the light comes on or the remote works normally, you're good to go. It's wise to keep a spare battery at home to avoid being stranded if the battery dies unexpectedly. Also, try to keep the key dry during daily use to extend battery life.
I do a lot of DIY work, and replacing the CS75 key battery isn't difficult. First, pull out the mechanical key part from the side of the key to make it easier to open the cover. The key shell is divided into upper and lower halves, and you can pry open the seam with your fingernail or a tool. The battery compartment inside may use a CR2032—make sure not to get the model wrong, as it could affect functionality. Gently remove the old battery, and when placing the new one, align it correctly—the positive side should face the cover. After installation, test the button response; if it's slow, there might be poor contact. While you're at it, wipe away any dust inside the key to keep it clean. It's recommended to replace the battery every two years, and choosing a branded product is more reliable. Wear gloves throughout the process to avoid static damage, and avoid using overly sharp metal tools. This way, the key will work smoothly after replacement.
