How to replace the air filter of Lavida?
3 Answers
The method to replace the air filter of Lavida: 1. Open the engine compartment cover of Lavida, secure the support rod, and locate the position of the air filter; 2. Use a screwdriver to loosen the screws around the filter cover, then remove the air filter; 3. Inspect the filter and replace it if necessary; 4. Place the new filter back into the air filter housing, paying attention to the correct orientation, reattach the cover, secure the clips, and tighten the screws to complete the replacement. The dimensions of the Lavida are 4670mm in length, 1806mm in width, and 1474mm in height, with a wheelbase of 2688mm. It features front-wheel drive, and its engine has a maximum power output of 110kw and a maximum torque of 250nm.
As an owner who has driven several Volkswagen models, I think changing the air filter for the Lavida is actually quite simple. First, you need to open the hood and locate that square black plastic box, usually near the battery. On the side of the box, there are metal clips or plastic fasteners—just pry them open with your fingers to lift the cover. When removing the old filter, remember to observe its installation direction; usually, there’s an arrow mark on the edge of the filter. Insert the new filter in the same direction, ensuring it fits snugly on all sides, then press the cover firmly until you hear a click to confirm it’s properly seated. Doing it yourself can save you the labor cost at the repair shop. I recommend checking it every 10,000 kilometers, and changing it more frequently in dusty areas. The whole process takes just about ten minutes, and even beginners can handle it easily.
Last week, I just helped my neighbor change the air filter for her Lavida. The key is to prepare the right tools. You'll need a Phillips screwdriver or a ratchet wrench, as some model years use screws to secure the filter box. First, disconnect the battery to avoid accidental contact. Open the hood and locate the black rectangular box near the windshield. Loosen the screws around it, being careful not to drop them into the engine bay. It's best to wear gloves when removing the old filter, as it's covered in dust and dead insects. Before installing the new filter, gently knead it a few times to loosen the pleats. Make sure the text on the side of the filter faces upward during installation. Finally, start the engine and listen for any unusual intake noises to confirm the seal is tight. I recommend using Mann or Mahle filters, which cost half as much when bought online compared to dealership prices.
