How to Replace the Air Filter in a Nissan Tiida?

1 Answers
SanMila
07/29/25 7:45pm
The method for replacing the air filter in a Tiida: 1. Remove the external screws; 2. Take off the pad below the storage compartment; 3. Take out the old filter and replace it with a new one. Below is a partial introduction to this vehicle: 1. The Tiida is a compact car with exterior dimensions of 4393mm in length, 1766mm in width, and 1539mm in height, a wheelbase of 2700mm, a minimum ground clearance of 167mm, a fuel tank capacity of 50 liters, and a trunk capacity of 435 liters. 2. The Tiida is equipped with a 1.6L L4 naturally aspirated engine, delivering a maximum horsepower of 122, a maximum power of 90 kilowatts at 6000 rpm, a maximum torque of 155 Nm at 4000 rpm.
Was this review help?
8
0
Share
More Forum Discussions

How to switch to S gear in an automatic transmission?

Press the car's brake pedal to slow down the vehicle. Bring the car to a complete stop on the road. Move the gear lever to the right from the D position to switch from D gear to S gear. Then, press the accelerator pedal to drive forward.
12
3
Share

How to use the P gear in an automatic transmission?

First, understand the working mode of the P gear. When in P gear, the transmission is locked. Press the brake pedal to stop the car. Shift the gear lever to N gear. Release the brake and engage the electronic parking brake. Turn off the engine, shift the gear lever to P gear, and the parking process is complete.
4
1
Share

How often should the air filter of the Volkswagen Phideon be replaced?

According to the vehicle's maintenance manual, the air filter of the Volkswagen Phideon should generally be replaced every 10,000 to 20,000 kilometers or every other maintenance interval. However, it is recommended to clean the air filter every 5,000 kilometers to reduce the formation of throttle sludge. The location of the car's air filter element is determined by the intake form and the engine structure. It is usually located in the air filter on the engine intake pipe. There are two types of air filters in cars: dry and wet. The dry type is made of paper or organic materials, while the wet type is made of metal wire mesh. The function of the air filter is to filter out particulate impurities in the air, ensuring that a sufficient amount of clean air enters the cylinder, preventing floating dust in the air from being sucked into the engine and accelerating the wear of the piston group and cylinder. The air filter is a type of filter, also known as an air filter cartridge, air cleaner, or style. It is mainly used in engineering vehicles, cars, agricultural vehicles, laboratories, sterile operating rooms, and various precision operating rooms as an air filter. During operation, the engine inhales a large amount of air. If the air is not filtered, the suspended dust in the air will be sucked into the cylinder, accelerating the wear of the piston group and cylinder. Larger particles entering between the piston and cylinder can cause severe cylinder scoring, which is particularly serious in dry and sandy working environments. The air cleaner is installed in front of the carburetor or intake pipe to filter out dust and sand particles in the air, ensuring that a sufficient amount of clean air enters the cylinder. Using a dirty air cleaner while driving will cause insufficient engine intake, incomplete fuel combustion, leading to unstable engine operation, reduced power, and increased fuel consumption. Therefore, the car must keep the air cleaner clean. The car air cleaner is a device that removes particulate impurities from the air, consisting of one or several clean air filter components. Its main function is to filter out harmful impurities in the air that is about to enter the cylinder, reducing early wear of the cylinder, piston, piston ring, valve, and valve seat. Therefore, before the air enters the cylinder, it must first pass through the fine filtration of the air cleaner. A dirty air cleaner can cause poor engine performance, excessive fuel consumption, and engine damage. When checking the air cleaner, if it is found to have little dust and light blockage, it can be cleaned with high-pressure air from the inside out and continue to be used. A severely dirty air cleaner should be replaced promptly.
14
2
Share

How to Use an Automatic Transmission Gear Lever?

The driver should look ahead. Hold the steering wheel with the left hand and lift the right foot off the accelerator pedal. Press the clutch pedal with the left foot. Use the right hand with appropriate force from the wrist and elbow to accurately push or pull into the selected gear position.
20
2
Share

How to Repair an Automatic Transmission That Has Taken in Water?

Do not drive or run the engine. When water enters the transmission, it will settle at the bottom of the gear oil inside the transmission. Open the drain plug at the bottom of the transmission to completely drain out the water and oil. Then, add new gear oil.
8
4
Share

How to Operate an Automatic Transmission?

Ensure the gear lever is in P (Park) or N (Neutral) position. Pay attention to coordinating the brake, handbrake, and accelerator properly. After shifting to D (Drive), release the handbrake while slowly lifting the brake pedal. Then gently press the accelerator to allow the vehicle to start slowly. Avoid stomping on the accelerator, as it not only wastes fuel but also damages the vehicle. Note: Do not release the brake pedal when shifting gears.
16
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.