How to Replace the 1.6L Lavida PCV Valve?

1 Answers
RyanFitz
07/30/25 4:02am
Prepare a T30 hex key and a flathead screwdriver. The new PCV valve can be purchased at a local auto parts store; Then open the hood and remove the engine cover, followed by disconnecting the four ignition coil connectors; Remove the screws around the PCV valve and detach the hose connected to the intake manifold. Finally, install the new PCV valve in reverse order.
Was this review help?
15
5
Share
More Forum Discussions

Is Water Wading Insurance Included in the First Year of a New Car?

Water wading insurance is not included in the first year of a new car's insurance coverage and needs to be purchased separately. Below is relevant information: 1. Vehicle Insurance: Vehicle insurance, also known as motor vehicle insurance or auto insurance, refers to a type of commercial insurance that covers personal injury or property damage caused by natural disasters or accidents involving motor vehicles. Auto insurance is a form of property insurance and is considered a relatively new category within the property insurance sector. 2. Water Wading Insurance: Water wading insurance, also referred to as auto loss insurance or engine special loss insurance (terminology varies by insurer but the essence remains the same), is a newly derived type of insurance. It essentially means that the car owner purchases an additional rider for the engine.
6
2
Share

No Parking Signs?

Inside a red circle, there is a blue background with a red cross, which means temporary parking is not allowed. If the red circle only contains a blue background or a red diagonal line, temporary parking is permitted, but long-term parking is prohibited. Regarding road markings that prohibit parking, there is a solid yellow line along the curb, which must be noted carefully. This is a ground marking indicating no parking. Parking in such areas will result in a fine. A yellow dashed line along the curb, consisting of alternating yellow and black lines, indicates a temporary parking zone. Short-term and temporary parking is allowed here, but the parking duration should not be too long.
15
0
Share

How many kilometers should the spark plugs be replaced for the Ford Kuga?

Ford Kuga's spark plugs have a service life of no more than 30,000 kilometers, and it is generally recommended to replace the spark plugs every two years or 30,000 kilometers. Under normal maintenance conditions, car spark plugs should be replaced after traveling 40,000 to 60,000 kilometers, but this may vary depending on the brand and engine. It is recommended to follow the owner's manual. The following standards can be referenced for maintenance and replacement: platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000 to 80,000 kilometers. Steps for replacing spark plugs: Open the hood, lift the plastic cover of the engine, remove the high-voltage ignition wires, and mark the position of each cylinder to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. When removing them, check for any external debris such as leaves or dust and ensure they are cleaned thoroughly. Place the new spark plugs into the spark plug holes, hand-tighten them a few turns, and then use the socket to tighten them further. Install the removed high-voltage ignition wires in the firing order and secure the cover.
12
3
Share

Where is the Cabin Air Filter Located in the Changan Alsvin?

Behind the glove compartment Here is the relevant introduction: 1. Cabin Air Filter: The cabin air filter is a filter installed in the car's air conditioning system. It can absorb dust particles, alleviate respiratory discomfort, reduce irritation for allergy sufferers, and protect the air conditioning cooling system. When a car is running with the air conditioning on, it draws in external air into the cabin. However, the air contains various particles such as dust, pollen, soot, abrasive particles, ozone, odors, nitrogen oxides, sulfur dioxide, carbon dioxide, benzene, etc. Without the cabin air filter, these particles would enter the cabin, not only contaminating the car's air conditioning system and reducing the performance of the cooling system but also causing allergic reactions, lung damage, irritation from ozone, and unpleasant odors, all of which can affect driving safety. 2. Cleaning Tips: If the filter is dirty, clean it by blowing compressed air from the opposite side. Hold the air gun about 5 cm (centimeters) away from the filter and blow at a pressure of 500 kPa (5.0 kgf/cm²) for approximately 2 minutes. The cabin air filter easily accumulates a lot of dust. Use a blower or high-pressure air to remove loose dust. Never wash it with water, as this can easily damage the filter.
8
1
Share

Which pipe should be blocked when the brake cylinder is leaking air?

Blocking the intake pipe will stop the leakage, but without air intake, the brakes will fully lock up and the vehicle won't be able to move. You can locate the leaking brake cylinder's intake pipe, cut and block it, then use a wrench to remove the screw at the back of the brake cylinder to release the air brake. The other wheels can still operate and brake normally! A faulty car brake cylinder can result in poor braking performance or the tires "locking up," causing the brake discs to overheat. In severe cases, it may lead to tire explosion and unsafe driving conditions. In such situations, it's necessary to promptly replace a new brake cylinder rubber cup.
7
4
Share

The Difference Between Plug-in and Charging Models

Differences between charging models and plug-in models: 1. Different usage location restrictions: A plug-in model product is inherently limited to places with power outlets, which creates constraints and prevents large-scale mobility. In contrast, charging models come with their own power source, providing the product with independent power, thus being less affected by environmental limitations. For example, a rechargeable desk lamp. 2. Price difference: For the same product, the charging model is inevitably more expensive than the plug-in version. This is because the charging model includes its own battery, increasing R&D costs, which necessitates a higher price to compensate for the difference.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.