How to Replace Car Door Frame Sealing Strips?

How to Deal with Trunk Water Leakage?

The methods to deal with trunk water leakage are as follows: 1. Replace the trunk sealing rubber strip or drill drainage holes at the bottom. 2. Remove the rear bumper and apply waterproof sealant. 3. If leakage occurs after installing a reverse radar, it might be due to wiring gaps. Replace the rubber gasket to seal it. 4. Check the drainage holes, clear any debris, and ensure the drainage channels are unobstructed. The causes of trunk water leakage are as follows: 1. Deformation of the trunk lid or aging of the surrounding rubber seals. Use a hose to spray water and observe where water drips in, or close the trunk after entering to see where light passes through, then mark the spots. 2. Aging of the sealing rubber strip, which requires replacement at an auto repair shop.

3

5

Share

What is the size of a motorcycle fuse?

Motorcycle fuses come in 10A, 15A, and 20A. Introduction to fuses: A fuse is a type of current fuse. When the circuit current exceeds twice the rated current of the fuse, it will melt within seconds, serving as a protective measure for the circuit. It is commonly used for overcurrent protection in automotive circuits and also for overcurrent protection in industrial equipment. Precautions for using fuses: During use, if an electrical device stops working, it may be due to a blown fuse, which should be replaced promptly. Always replace the fuse with the rated current value specified on the fuse box cover, and do not use a fuse with a higher rated current. If the new fuse blows immediately, it indicates a possible fault in the circuit system, which should be inspected and repaired as soon as possible. In the absence of a spare fuse, during emergencies, you can replace it with a fuse from another device that does not affect driving or safety. If a fuse with the same current load cannot be found, you can use one with a lower rated current than the original fuse as a substitute.

17

1

Share

Why is the car loud when starting?

It is normal for a car to be loud when starting. During a cold start, the engine oil pressure takes time to build up, resulting in poorer lubrication and thus louder noise. Additionally, after a cold start, the engine runs at a higher idle speed to reach the optimal operating temperature quickly, which may make the noise seem louder. The noise will gradually decrease as the idle speed drops until it disappears. Here is some related information about idle speed: 1. Introduction: Idle speed is an operating condition of a car where the engine runs in neutral gear. The engine speed during idle is called the idle speed, which can be adjusted by modifying the throttle opening. Idle speed means the engine is "working but not producing output." 2. Driving idle: When the car is in gear without pressing the accelerator pedal or when the accelerator pedal is released while driving, maintaining the minimum throttle opening, the engine speed matches the parking idle speed. This state is referred to as driving idle.

10

3

Share

What is the fuel tank capacity of the Qin PLUS DM-i?

The BYD Qin PLUS DM-i has a fuel tank capacity of 48 liters, as officially announced by the manufacturer. This information can also be found in the vehicle's configuration sheet. The Qin PLUS DM-i uses 92-octane fuel, with a fuel consumption of 3.8L per 100 kilometers, allowing a maximum range of 1263 kilometers on a full tank. The BYD Qin PLUS DM-i measures 4765*1837*1495 mm in length, width, and height respectively, with a wheelbase of 2718 mm. It is equipped with a 1.5-liter naturally aspirated engine that delivers a maximum power of 81 kW at 6000 rpm and a maximum torque of 135 Nm at 4500 rpm. This engine features multi-point fuel injection technology and uses an aluminum alloy cylinder head and block. The electric motor paired with this engine produces a maximum power of 132 kW and a maximum torque of 316 Nm. The front suspension is a MacPherson independent suspension, while the rear suspension uses a torsion beam non-independent suspension. The MacPherson suspension is known for its simple structure, compact size, and low cost. The torsion beam rear suspension helps to maximize rear passenger space and trunk capacity. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically done by observing the fuel gauge inside the vehicle. Under normal circumstances, the fuel gauge accurately reflects the fuel level. The fuel gauge usually has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel unexpectedly. During actual refueling, the amount of fuel added may exceed the calibrated capacity. This is because the manufacturer's specified tank capacity is measured from the bottom of the tank to the safety limit, and there is additional space from the safety limit to the tank opening. This extra space ensures that the fuel can expand safely when temperatures rise without overflowing. If fuel is filled up to the tank opening, the actual refueling volume may exceed the specified tank capacity.

15

5

Share

What are the symptoms of a damaged catalytic converter in a car?

A damaged catalytic converter can manifest the following symptoms in a car: 1. The exhaust emits a strange and unpleasant odor. 2. The car engine overheats and experiences premature excessive wear. 3. The car engine lacks power and produces abnormal noises. The catalytic converter is an external purification device installed in the car's exhaust system, which converts harmful carbon monoxide, hydrocarbons, and nitrogen oxides from the car's exhaust into harmless carbon dioxide, water, and nitrogen through oxidation and reduction reactions. The causes of catalytic converter damage include: 1. Blockage due to deposits from ethanol gasoline, sulfur-phosphorus chemical complexes, or lead-manganese metal deposits, as well as melting and blockage of the ceramic substrate caused by engine exhaust flames. 2. Loss of activity of the surface precious metals, rendering them unable to catalyze reactions. 3. Prolonged exposure to high temperatures, leading to thermal deactivation.

12

4

Share

What are the brands of Chaoyang tires?

Chaoyang tire brands mainly include Chaoyang, Goodride, Westlake, and Roadone. Chaoyang tire field: Chaoyang tire is a brand under Zhongce Rubber Group Co., Ltd. Zhongce owns well-known tire brands such as Chaoyang, Westlake, Goodride, Roadone, Yadu, and ARIS-UN. Chaoyang tire products currently cover passenger car tires, commercial car tires, engineering vehicle tires, industrial and agricultural vehicle tires, and two-wheeler tires. Chaoyang tire scope: Chaoyang tire products currently cover passenger car tires, commercial car tires, engineering vehicle tires, industrial and agricultural vehicle tires, and two-wheeler tires. Each series has various performance tires to meet the personalized needs of consumers. Chaoyang tire advantages: The biggest advantage is not wear resistance, but the balance of performance in terms of quietness, grip, and fuel efficiency. As a domestic brand, price is its biggest advantage, offering very high cost performance.

1

2

Share

How to Replace Car Door Frame Sealing Strips?

How to Deal with Trunk Water Leakage?

What is the size of a motorcycle fuse?

Why is the car loud when starting?

What is the fuel tank capacity of the Qin PLUS DM-i?

What are the symptoms of a damaged catalytic converter in a car?

What are the brands of Chaoyang tires?

What do A and M stand for in car air conditioning?

Can a China VI gasoline vehicle be converted to natural gas?

Can Touring Motorcycles Be Used for Long-Distance Travel?

Why does the Aochi 1800 lack high and low speed options?