How to Replace a Lost Buick Excelle Key?

Will the Transmission of a Flooded Car Get Water Inside?

Whether the transmission of a flooded car gets water inside depends on the vehicle's condition. Relevant explanations about water entering the transmission of a flooded car are as follows: 1. Vehicle in motion: Generally, as long as the vehicle is still moving and the engine is not turned off, even if the transmission is submerged in water, it will not get water inside. Although the transmission has a vent hole, because the transmission is working, there is pressure inside the housing, preventing water from entering. 2. Vehicle stationary: When the vehicle is parked and the transmission is not working, if the housing is submerged in water, water can enter through the vent hole. In this case, the transmission must be inspected, and the transmission fluid must be replaced. If not replaced within 4 hours, even if repaired three to five days later at a repair shop, transmission failure may still occur after five months.

12

2

Share

What Causes Uneven Airflow from Car Air Conditioning Vents?

If the airflow is weaker when using the external circulation mode but normal with internal circulation, it is likely due to a clogged cabin air filter. In this case, replacing the cabin air filter should resolve the issue. Internal Air Duct Flap Issue: If the airflow remains weak regardless of the circulation mode, it may indicate problems with the internal air duct flap or similar components. This situation is less common than the previous one. It is recommended to first inspect the cabin air filter. Replacing a dirty air filter that is obstructing airflow into the vehicle may solve the problem. How Car Air Conditioning Works: The car air conditioning refrigeration system consists of a compressor, condenser, receiver-drier, expansion valve, evaporator, and blower motor. These components are connected through copper (or aluminum) pipes and high-pressure rubber hoses to form a sealed system. When the refrigeration system operates, the refrigerant circulates through this closed system in different states.

4

1

Share

What type of suspension does the Enclave use?

The Enclave uses a MacPherson strut independent suspension for the front suspension and a multi-link independent suspension for the rear suspension. More details about the suspension are as follows: 1. The MacPherson strut suspension is the most widely used suspension, and most cars use it for the front suspension. 2. The MacPherson strut suspension has a relatively simple structure, consisting of only an L-shaped control arm, and it hardly occupies any space in the engine compartment. 3. The multi-link suspension is also a common type of independent suspension. It is an improvement based on the double-wishbone suspension, where the two wishbones are replaced by four links. 4. There is no connection between the two wheels on the same axle in an independent suspension, so there is no interference between them. In contrast, non-independent suspensions have a connection between the two wheels on the same axle, leading to interference, which is why non-independent suspensions are inferior to independent suspensions in terms of handling and comfort.

1

3

Share

Where to Buy Jiangnan TT Car?

Jiangnan TT car is no longer available for purchase, with the last model discontinued in 2010. More information about Jiangnan TT is as follows: Introduction: The Jiangnan TT model was launched by Zotye Auto and is a micro car. It is equipped with a 0.8-liter 36-horsepower three-cylinder naturally aspirated engine, paired with a four-speed manual transmission. The vehicle uses 92-octane gasoline with a multi-point fuel injection system and features front-engine, front-wheel-drive layout. It belongs to the micro car category. Body Dimensions: The overall body dimensions are: length 3300 mm, width 1405 mm, height 1410 mm, wheelbase 2175 mm, front track 1215 mm, rear track 1200 mm, minimum ground clearance 150 mm. It is a five-door, four-seat hatchback with a fuel tank capacity of 30 liters.

4

1

Share

What is the difference between mild hybrid and hybrid?

48V mild hybrid is more suitable for driving in urban areas with frequent traffic lights, as it is more fuel-efficient. Due to different working conditions, the fuel consumption of mild hybrid and hybrid electric vehicles varies. Mild hybrid: Mild hybrid vehicles are equipped with small motor power and small battery capacity. Mild hybrid is one type of hybrid system. The mild hybrid system was widely used by most automakers in the early years because battery costs were high at that time, and adopting hybrid would increase costs, so many automakers opted for mild hybrid solutions. The motor in mild hybrid vehicles operates less frequently, with most of the power still provided by the internal combustion engine. The motor power in mild hybrid vehicles is relatively small, and the battery capacity is also limited. Hybrid: The most common hybrid vehicles on the market today are primarily popular because they qualify for green license plates and receive subsidies. Hybrid vehicles add one or more drive motors on the basis of the traditional fuel engine, which can not only assist the engine in generating stronger power but also independently drive the vehicle using the motor under fixed conditions such as low speed or constant speed. Especially in congested urban environments, hybrid vehicles demonstrate significant fuel-saving effects.

19

2

Share

What is the horsepower of the 4108 engine?

Most 4108 engines have a horsepower of around 140. Horsepower refers to the engine's power, which is an important performance parameter. Power is used to measure how much work an engine can perform per unit of time. Engines with higher power have stronger performance but also higher fuel consumption. The power of an engine is related to its speed and torque. The higher the speed, the higher the engine's power. Similarly, the greater the torque, the higher the engine's power. High-speed engines perform more work per unit of time, while high-torque engines deliver greater torque with each output. Many car manufacturers use turbocharging technology to enhance engine performance. Turbocharging technology can increase the engine's air intake without increasing its displacement. Principle of engine turbocharging: Turbocharging utilizes the inertial force of exhaust gases produced by the engine to drive the turbine in the turbine chamber. The turbine, in turn, drives the coaxial impeller, which compresses the air delivered through the air filter pipeline, pressurizing it before it enters the cylinders. This increases the air intake into the cylinders and also raises the fuel intake.

3

2

Share

How to Replace a Lost Buick Excelle Key?

Will the Transmission of a Flooded Car Get Water Inside?

What Causes Uneven Airflow from Car Air Conditioning Vents?

What type of suspension does the Enclave use?

Where to Buy Jiangnan TT Car?

What is the difference between mild hybrid and hybrid?

What is the horsepower of the 4108 engine?

Is it necessary to cancel ETC if not in use?

Are the Rear Axle and Transfer Case Parallel?

How to Solve Sticky Car Windows?

What are the reasons for the vehicle body crossing the line during parallel parking?