How to Remove Water Stains from Car Windows?

1 Answers
MacJasper
07/30/25 12:15am
Apply toothpaste to a towel, then wipe the glass, and finally rinse with clean water to remove water stains from the glass. Use a clay bar, wet the glass, and rub back and forth on the areas with water stains to remove them.
Was this review help?
9
2
Share
More Forum Discussions

How to use the Q3 dash cam?

When the screen is lit and in recording mode, press the "MENU" button to turn the audio recording on/off. When the screen is lit, press the "OK" button once to stop recording, and vice versa. Press the "MODE" button to switch between the three functions: photo, playback, and recording. Press the "OK" button to confirm the currently selected function.
16
4
Share

How to engage the R gear when it's on the left side of first gear?

R gear indicates the vehicle is in reverse. To operate it, you typically need to press the safety button on the shift lever before moving the lever to the "R" position. Press the gear lever downward and then push it to the upper left to engage the R gear. Do not force the shift into R gear when the vehicle hasn't come to a complete stop, as this may damage the transmission.
12
4
Share

How to resolve the u015187 fault code?

u015187 fault code indicates a communication loss with the airbag system restraint control module. It is necessary to inspect the airbag connector wiring harness to check for proper contact. The fault code should be cleared strictly according to the method specified for the specific vehicle model. Simply removing the negative battery ground cable to clear the fault code is not recommended.
8
3
Share

How to Properly Start and Stop an Audi Q5L?

First, enter the vehicle and press the brake pedal with your foot—the brake is the one on the left. After pressing the start button, the car will start. If you need to move the car, press the brake again and shift the gear to D (Drive) mode. Once the gear is shifted to D mode, release the handbrake by pressing it downward once. Gradually release the brake pedal to start moving the car. To increase speed, press the accelerator pedal. To stop, press the brake pedal, then press the [P] (Park) button on the gear lever, and finally pull up the handbrake button to complete the parking process.
17
0
Share

How to Adjust SUV Seating Position for Comfort?

Adjust the seat position by first setting the height, then adjusting the forward/backward position. The forward/backward distance should ensure that your knees are bent at approximately a 90-degree angle for optimal comfort. The driver's arms should be positioned so that when fully extended, both wrists naturally rest on the steering wheel, which is the most suitable distance. The seatbelt must fit snugly against the body. A loose seatbelt will reduce its cushioning effect during a safety incident.
2
3
Share

How to turn on the rear wiper of the XRV?

Push the lever inward, and the windshield washer fluid will spray automatically. The default position is AUTO, and the wiper will work automatically when the vehicle senses increased rain. The rear wiper switch is turned on by rotation. Rotate the switch to OFF to turn it off, to INT for intermittent operation, and to ON for continuous operation.
8
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.