How to Remove the Wiper Blades on a Haval H6?
3 Answers
Haval H6 wiper blade removal method is as follows: To remove the Haval H6 wiper blades, first fully raise the wiper arm. Then adjust the angle of the wiper blade to make it form a 90-degree angle with the wiper arm. Lift the rubber blade, use one hand to pry open the rubber blade horizontally while pressing down firmly on the bracket with the other hand to separate the wiper blade from the arm, allowing the entire wiper blade assembly to be removed. Additional information: 1. Wipers, also known as windshield wipers or windscreen wipers, are devices used to wipe away raindrops and dust attached to the vehicle's windshield, improving driver visibility and enhancing driving safety. 2. The power source of the wiper comes from an electric motor, which is the core of the entire wiper system. The quality requirements for the wiper motor are quite high. It uses a DC permanent magnet motor. The wiper motor installed on the front windshield is generally integrated with the worm gear mechanical part. The worm gear mechanism serves to reduce speed and increase torque, with its output shaft driving a four-bar linkage that converts continuous rotational motion into left-right oscillating movement.
As a daily user of the Haval H6, removing the wipers is a fairly simple operation. After parking and turning off the engine, lift the wiper arm vertically, locate the small clasp button at the connection point, press it, and smoothly pull off the old wiper blade. Be careful not to let the arm snap back and damage the windshield—I usually place a soft towel on the glass as a precaution. The Haval H6's design is user-friendly, with standard and easy-to-remove connectors, though older models might have some stiffness; a gentle shake usually loosens it. DIY saves money and ensures safety. I remove and inspect the rubber strips every six months, replacing the blades if cracks appear. The sizes are 26 inches for the driver’s side and 16 inches for the passenger side—proper fit is crucial to avoid obstructing visibility during rain. Regular wiper maintenance reduces driving risks—don’t wait until they fail to clean properly. This small routine protects your family’s safety.
As a car DIY enthusiast, removing the H6 wiper blades is a piece of cake. After turning off the engine, lift the wiper arm vertically to secure it, expose the connector to locate the U-shaped hook clip, and press down the protrusion with your finger to easily remove the wiper. Don't forget to wear gloves to avoid scratches, and place a cloth under the arm spring to prevent rebound due to its strong tension. Pay attention to details: the connector might accumulate dust affecting removal, so clean it before operation to ensure smoothness. The job is done with minimal tools, and it's a good opportunity to check for signs of aging like hardening or fraying on the rubber strips. The Haval H6 interface has strong compatibility, so after removal, choose new blades in 26/16-inch sizes for a one-step installation. The joy of DIY lies in timely maintenance, extending wiper lifespan to avoid frequent trips to the repair shop, combining hands-on fun with practical protection for driving safety.
