How to Remove the Wiper Blade Rubber?

[DiLevi]

The method to remove the wiper blade rubber is: 1. Turn the car key to the power-on position, switch the wiper lever once to make the wiper stay in the upright position; 2. Press the small square button on the wiper arm and pull out the old wiper rubber. The wiper, also known as the windshield wiper, is a blade structure installed in front of the windshield, consisting of a motor, reducer, four-bar linkage, wiper arm spindle, wiper blade assembly, etc. The main function of the wiper is to remove raindrops, debris, and dust attached to the vehicle's windshield to improve the driver's visibility and enhance driving safety.

[SanJosephine]

I think replacing the wiper blade rubber insert myself is a cost-saving DIY task that's simple and easy to handle. First, park the car and turn off the engine, then lift and secure the wiper arm to avoid damaging the windshield or car body during operation. Next, check for a small clip or button at one end of the wiper blade, gently press or slide it to release the rubber insert. Carefully pull out the old rubber insert without using excessive force to prevent damaging the frame. Then, clean any dust or dirt from the wiper frame with a soft cloth, align the new rubber insert correctly and insert it until you hear a click indicating it's secured. Be cautious not to cut your fingers on sharp edges, especially since old rubber inserts can become brittle and break easily. It's recommended to replace the rubber insert every six months to extend the lifespan of the entire wiper blade, save money, and be eco-friendly—replacing the whole set is just wasteful. Before starting, it's best to check your vehicle's manual since mechanisms may vary slightly by brand, like BMW or Toyota, and online video tutorials can also be very helpful.

[MacNaomi]

I often help friends with this, and replacing wiper blades is actually quite quick. After parking, make sure the engine is turned off—safety first to avoid accidental starts. Lift the wiper arm and wrap it with a towel to prevent it from swinging. Then, focus on the wiper blade: there’s a small release clip or button at the end—just press or push it gently to loosen the blade. Slowly pull out the old blade, clean any residue, and check for severe wear. Install a new blade of the matching size, align it with the groove, slide it in, and secure it before testing for smooth movement. Important reminder: don’t skip protective gloves, and inspect the wiper frame for cracks. After replacement, driving in the rain will be clearer and safer, and the cost is much lower than replacing the entire wiper—perfect for regular maintenance. The whole process takes about ten minutes, but being thorough never hurts.

[MacHaven]

I've replaced the wiper blades a few times and found it quite easy, even for beginners. Park the car, turn off the engine, and lift the wiper arm to secure it. Locate one end of the blade, press the clip to release it, then slowly pull out the old blade without forcing it. When installing the new blade, align it properly, insert it into the groove, and press it flat to secure. Remember to clean the frame to prevent rust and test for smooth wiping motion. It's a quick and simple process that saves money on maintenance.