How to Remove the Turn Signal Light of Arrizo 7?

[ManuelRose]

Arrizo 7 turn signal light removal method: First, use pliers to bend a piece of iron wire into a hook for easier reassembly. Then, use a flat-head screwdriver to gently pry open the turn signal light from its edge. Carefully remove the turn signal light by hand. Finally, unplug the turn signal light's wiring connector to complete the operation. The Arrizo 7 is a model under Chery Automobile, with body dimensions of 4652mm in length, 1825mm in width, and 1483mm in height, and a wheelbase of 2700mm. In terms of appearance, the Arrizo 7 features a smooth roofline arc design and a side view with a diving dual-waistline, showcasing a dynamic and poised stance. The upper waistline runs through the door handles, integrating the side profile for a sleek and elegant body design.

[Jayce]

I've tried removing the Chery Arrizo 7's turn signal lights a few times. First, make sure the car is turned off and the battery's negative terminal is disconnected to avoid short circuits or electric shocks. Gather the necessary tools: a Phillips screwdriver and a small wrench will do. The turn signal is located on the fender above the front wheel—it's best to do this in a garage to avoid getting dirty, especially on rainy days. Check the inner side of the wheel; there are several screws securing it. After loosening the screws, gently pry open the fender cover. Don't force it, as the clips can break easily. Once you see the light assembly, unplug the electrical connector and then remove the screws holding the light socket. The whole process takes about half an hour. After removal, check the bulb's condition—don't rush to reinstall it. Also, clean the slot to prevent future issues. Safety first—I recommend beginners watch YouTube tutorials to avoid mistakes.

[Rodrigues]

As someone who enjoys tinkering with cars, I've taken apart the Chery Arrizo 7 turn signal multiple times. Prepare a screwdriver and pliers, and removing the wheel first makes the job easier. The turn signal is located inside the fender; disconnect the battery to prevent electric shock risks. Then loosen the three mounting screws, carefully pry open the plastic cover with a screwdriver, and unplug the wiring connector. If the bulb socket is stuck, don't pull forcefully—gently wiggle it to remove. When replacing the bulb, check the base for rust and clean it promptly if necessary. Don't take too long during the process to keep the components dry. The job isn't difficult but requires attention to detail. After a few tries, you'll get the hang of it.

[OIsabela]

I once taught a friend how to remove the turn signal light on an Arrizo 7. Prepare a cross-head screwdriver and gloves. Make sure the car is turned off and parked stably, then locate the light position above the front wheel. Loosen a few screws, pry open the cover, unplug the electrical connector, and remove the light. Don’t forget to check if the filament is damaged, and test if it lights up properly after reassembly. Be careful not to damage the wiring.