How to Remove the Tiida Dashboard?

[VonAshley]

Method for removing the Tiida dashboard: 1. Gently unclip the retaining ring and remove the four screws on the dashboard; 2. Take off the rear cover; 3. The dashboard circuit board will then be visible, completing the disassembly. The Tiida is a vehicle produced by Dongfeng Nissan Passenger Vehicle Company, serving as the hatchback version of the Latio, and it uses the same engine as the Latio with no changes in power performance. The Tiida is equipped with a 1.6L naturally aspirated HR16 engine jointly developed by Nissan and Renault, delivering a maximum horsepower of 122 PS and a maximum torque of 155 Nm. In terms of body dimensions, the Tiida measures 4.250 meters in length, 1.695 meters in width, and 1.535 meters in height.

[Pluto]

Before disassembling the Qashqai's dashboard, I need to prepare the tools. Get a flathead screwdriver, a plastic pry bar, a Phillips screwdriver, and some anti-slip gloves. It's best to choose a well-lit place to work to avoid missing small components in the corners. The first step is to disconnect the negative terminal of the battery—this is crucial to prevent short circuits or electrical burns, especially avoiding accidental contact with the airbag system. The Qashqai's dashboard is usually located behind the steering wheel. Carefully pry open the dashboard cover trim with the pry bar, avoiding excessive force to prevent scratching the interior plastic. Next, remove the mounting screws and slowly take out the dashboard assembly. Check the wiring connectors while doing this, pressing the clips firmly before disconnecting them. When reinstalling, align the clips properly to ensure a secure fit. The process isn’t difficult but requires patience. Last time, I replaced the dashboard lights myself, which took about an hour and a half. Make sure to test the lights before finishing up, and don’t forget to reconnect the battery. Safety first—wearing gloves provides extra protection.

[VanDeclan]

I once disassembled the dashboard of my Nissan Tiida, and I was quite nervous. I just used a screwdriver from home and an old credit card as a makeshift pry bar. Remember to always disconnect the battery first—some people online mentioned that accidentally touching the airbag system could cause it to deploy. Start by prying open the decorative cover below the steering wheel, take it slow, and don’t yank too hard. The screws on the Tiida aren’t deep, and once removed, the dashboard can be gently pulled out. However, there are many wire connectors, so make sure to note their positions to avoid mixing them up. While disassembling, I accidentally loosened a wire, and the dashboard went dark—later, a friend helped me reconnect it. Looking back, if you’re modifying or repairing something, it’s best to have a repair manual handy, as beginners can easily make mistakes and damage the car. Simple tasks can be DIY, but for more complicated ones, it’s better to go to a professional shop—saves time and effort. I learned to keep backup parts just in case. Never overlook safety—disconnecting the battery is a must, don’t cut corners.

[DelJosephine]

Disassembling the Qashqai dashboard, I have years of experience: Just prepare some plastic pry tools and a screwdriver. First, disconnect the battery to prevent accidents. Pry open the dashboard cover, remove the screws, and carefully take out the dashboard. The key is the wiring connectors—pull them out gently to avoid damaging the clips. The Qashqai's design is relatively simple; it can be done in just over 10 minutes. However, if the airbag light is on, never attempt it—it's dangerous. Use soft-tipped tools to avoid damaging the interior. Beginners often rush and make mistakes, like accidentally blowing a fuse. It’s advisable to check the vehicle manual for guidance or have it handled at a 4S shop for safety. Move slowly and ensure proper alignment when reassembling. The process is similar for other models—safety comes first.