How to Remove the Steering Wheel of a Zotye T600?
3 Answers
The specific steps for dismantling the steering wheel of a Zotye T600 are as follows: 1. Disconnect the Zotye T600 battery. 2. Turn the Zotye T600 steering wheel approximately 90 degrees. 3. Insert a small flat-head screwdriver from front to back into the hole behind the steering wheel. 4. Insert the screwdriver head between the retaining spring and the airbag hook, and gently pry the retaining spring away from the hook with a skillful upward force. The airbag side will automatically pop slightly towards the seat direction. 5. Then, turn the Zotye T600 steering wheel 180 degrees and continue to pry open the retaining spring on the opposite side (if it is difficult to pry, it is recommended to gently press down on the already lifted side of the airbag, but do not use excessive force to press the buckle back into the retaining spring). 6. Remove the airbag, unclip the yellow safety buckle behind the airbag, and then unplug the airbag connector to remove the airbag. 7. Unplug the airbag coupling coil connector located above the inside of the steering wheel. 8. Use a spline wrench to loosen the central fixing bolt of the steering wheel counterclockwise. 9. Finally, carefully remove the Zotye T600 steering wheel (be cautious to prevent accidental rotation of the coupling coil below).
As an owner who has DIY-modified the steering wheel, I believe that removing the steering wheel of a Zotye T600 requires a Phillips screwdriver, a 19mm socket wrench, and a pry bar. First, disconnect the battery for five minutes to avoid accidental airbag deployment. There are small cover plates on both sides of the steering wheel; pry them open to reveal the T30 screws securing the airbag. After unscrewing these, the airbag module can be gently lifted—remember to press the clip when disconnecting the yellow airbag connector. Next, remove the large 19mm nut in the center of the steering wheel. It's crucial to mark the positions of the steering wheel and the steering column to avoid misalignment during reassembly. Finally, use a steering wheel puller to apply even force and slowly pull it off—avoid hammering it forcefully. The entire process takes about half an hour. For first-timers, I recommend finding a tutorial video online specific to your vehicle model and following along.
Auto repair shop technician here to talk about this. For Zotye T600 steering wheel removal, you must first deal with the airbag: After power disconnection, remove the Torx screws on the back of the steering wheel, and be cautious with the wiring harness when taking off the airbag module. The central fixing nut should be unscrewed with a socket wrench. The steering wheel and steering column have alignment pins, so it's advisable to mark them with a marker pen. If the steering wheel is extremely tight, a puller tool is the most reliable solution. Our shop often uses a three-jaw puller, slowly turning it against the steering column from the holes on the back of the steering wheel. DIYers might lack specialized tools, and forcing it open could easily damage the clock spring or scratch the steering wheel leather.
