How to Remove the Steering Wheel of a Volkswagen Passat?
2 Answers
Volkswagen Passat steering wheel removal method is as follows: 1. First, disconnect the negative terminal of the battery, then remove the combination switch cover. 2. There are two small holes on the back of the steering wheel. Insert a thin screwdriver into each of these holes and push the retaining spring towards the center of the steering wheel to remove it. It is important to note that the steering wheel should not be forcibly removed, as this may cause noise when reinstalling. 3. The steering wheel not only controls the direction of the vehicle but can also help identify faults. Paying attention to it while driving is beneficial for both safety and the vehicle. Generally, the most comfortable way to hold the steering wheel is with both hands parallel to each other.
I'm quite familiar with removing the Passat steering wheel - did it last time when replacing the multifunction buttons. Remember to disconnect the battery first! Use a 10mm socket to remove the negative terminal, then wait ten minutes for the airbag capacitor to discharge. There are small holes on both sides of the steering wheel's lower edge - insert a thin screwdriver to release the airbag spring clips, then the entire airbag module can be lifted out. Key point: Before disconnecting the airbag plug, use a plastic pry tool to flip open the yellow safety lock, never pull the wires forcefully. The large center nut requires a 19mm socket, and you must mark the relative position between steering wheel and column before loosening it. Important reminder: DIY removal carries significant risks, as improper handling may trigger fault codes. If unsure, it's safer to have a professional handle it.
