How to Remove the Spare Tire of Wuling Hongguang?
3 Answers
The method to remove the spare tire of Wuling Hongguang is as follows: simply loosen the screw in the center of the spare tire to take it off. The spare tire is located under the floor of the rear trunk; you can see it by opening the trunk floor. Taking the Wuling Hongguang 2021 1.5LS Basic LAR model as an example, its dimensions are 4420mm in length, 1685mm in width, and 1755mm in height, with a wheelbase of 2720mm, and the body structure is a passenger car. In terms of power, it is equipped with a 1.5L naturally aspirated engine, delivering a maximum power of 73kW and a maximum torque of 140Nm, paired with a 6-speed manual transmission.
I remember last time my Wuling Hongguang had a flat tire, and I needed to get the spare tire in a hurry. The spare tire is stored under the car, so first locate the vehicle tool kit, which contains a jack and a wrench. Find a flat spot to park, engage the handbrake to ensure safety. Crawl under the car to check the position of the spare tire mounting bolt, then use the wrench to loosen it counterclockwise. Sometimes the bolt is rusty and hard to turn—spray some rust remover or tap it lightly before trying again. Once loosened, the spare tire will hang down; hold it steady and pull it out. Spare tires are usually full-size and heavier than regular tires, so don’t try to handle it alone to avoid injury. After removing it, check the tire pressure to ensure it’s adequate, preventing any last-minute embarrassment. Regularly maintain the spare tire cover to prevent dust buildup, which could affect its next use. Stay calm throughout the process—take it step by step, and you’ll get it done.
Removing the spare tire of the Wuling Hongguang is actually quite simple. As a beginner, I was a bit confused the first time I did it: the spare tire is located in the middle under the car, and you can see the fixing screw on the metal frame by squatting down. First, prepare the jack and wrench, which are in the tool kit in the corner of the trunk. Park on a level surface, shift into neutral, and engage the handbrake to prevent the car from rolling. Use the wrench to slowly loosen the screw—if it's too tight, don't force it; just wiggle it gently a few times to loosen it. After removing it, carefully lift the spare tire—it's quite heavy and might dirty your hands. It's recommended to wear gloves for easier handling. Don't forget to clean it after changing the tire and check the tire pressure regularly to avoid a flat tire.
