How to remove the spare tire of Toyota Prado?
2 Answers
Here are the steps to remove the spare tire of Toyota Prado: 1. Open the trunk and locate a rotating switch. Turn the cover of this rotating switch to the right to open it. 2. You will see a nut that secures the spare tire underneath the vehicle. 3. Use a nut wrench to rotate the nut clockwise to loosen it. 4. Once the nut is loosened, the tire will drop from the bottom but remain connected by a cable. 5. At this point, pull out the spare tire, rotate the plastic plug in the center of the wheel to remove it, and then disconnect the cable. Here is more information about Toyota Prado: 1. The Toyota Prado is positioned as a mid-to-large SUV, with body dimensions of 4840mm in length, 1885mm in width, and 1890mm in height, and a wheelbase of 2790mm. 2. The entire lineup is equipped with a 3.5-liter V6 naturally aspirated engine, paired with a 6-speed automatic transmission. It delivers a maximum power of 206KW, maximum horsepower of 280PS, maximum torque of 365Nm, maximum power speed of 6000rpm, and maximum torque speed of 4500rpm.
I often take the spare tire when camping with my Prado, so I have some experience. The first step is to open the trunk—there's a toolkit under the floor mat. Take out the socket wrench and extension bar. Locate the release hole at the bottom of the rear bumper, insert the extension bar, and turn it counterclockwise; the chain will loosen, and the spare tire will slowly lower. Once the spare tire touches the ground, just pull it out. Make sure to squat steadily and hold on to something to avoid the spare tire dropping on your feet. It’s advisable to regularly check the spare tire’s pressure and aging condition—otherwise, if you get a flat on the road and can’t replace it, you’ll be in trouble. I do this before every long trip in case I encounter gravel roads or get stuck. Remember not to misplace the toolkit, or you’ll waste time searching for it in a critical moment.
