···
Log in / Register

How to Remove the Spare Tire of the New Buick GL8?

1 Answers
BrantleyFitz
07/29/25 6:51pm
The method for removing the spare tire of the new Buick GL8: Attach the folding wrench to the extension rod, then insert the chisel end of the rod diagonally through the hole in the rear bumper. Insert the lifting shaft into this hole, then turn the folding wrench counterclockwise until the spare tire lowers to the ground. Continue turning the wrench until the spare tire loosens, allowing it to be removed. The spare tire is located beneath the trunk, and all tools required for its removal are stored in the rear compartment of the vehicle. Taking the 2021 new Buick GL8 as an example, it is an MPV with body dimensions of 5238mm in length, 1878mm in width, and 1776mm in height, with a wheelbase of 3088mm and a curb weight of 1880kg. This vehicle is equipped with a 2.0T turbocharged engine, delivering a maximum horsepower of 237PS, a maximum torque of 350Nm, and a maximum power of 174kW, paired with a 9-speed automatic transmission.
Was this review help?
14
5
Share
More Forum Discussions

Should the Accord AC be ON or OFF?

The Accord AC should be set to ON for cooling and OFF for heating. Below is a brief introduction about the AC function: 1. AC: Stands for air-conditioning, which means air regulation. 2. The difference between using AC and not using AC is that one utilizes the air conditioning compressor while the other does not. Simply put, use AC for cooling in summer and turn it off in winter to utilize the radiator temperature for heating. 3. The A/C button controls the air conditioning. When the button's light is on, it means the compressor is working, which increases fuel consumption and is mainly used for cooling and blowing cold air.
3
1
Share

What is the autonomous driving level of the Huawei Arcfox Alpha S?

The Huawei Arcfox Alpha S has an autonomous driving level of L4. Here is some information about L4 autonomous driving: 1. L4 autonomous driving: Highly automated, still equipped with interfaces like a steering wheel to allow for manual control when necessary. 2. After activating autonomous driving, the computer will navigate its own route once the destination is set, requiring no intervention for full driving, except in specific areas like highways or urban zones. However, it can already handle most 'dynamic driving tasks.' Following the L4 autonomous driving phase, the technology is still in the development stage, and there are very few cars with L4 autonomous driving technology available on the market.
4
2
Share

Why does the Highlander display show 'battery charging'?

The Highlander display showing 'battery charging' may occur due to the following reasons: 1. Insufficient driving time leading to incomplete battery charging. 2. Using power-consuming devices like navigation, music system, or air conditioning after starting the vehicle. 3. Continuous operation of the engine start-stop technology - when braking, if the battery isn't fully charged, the engine keeps running to charge instead of shutting off. In this case, since the start-stop system is active, the display will show the start-stop indicator along with the 'charging' notification to inform the driver that the vehicle isn't in start-stop mode because the battery is being charged.
19
3
Share

Where is the OBD port located on the Citroen C4?

The OBD port on the Citroen C4L is located at the bottom of the center console, just above the USB port. Here is some information about the OBD port: 1. OBD stands for On-Board Diagnostics. 2. The OBD system monitors multiple systems and components, including the engine, catalytic converter, particulate filter, oxygen sensors, emission control system, fuel system, EGR, etc. 3. When an emission-related fault occurs, the ECU records the fault information and related codes, and alerts the driver by illuminating the malfunction indicator lamp.
14
5
Share

How to bleed the electric water pump on a Volvo XC60?

The bleeding method for the Volvo XC60 electric water pump is as follows: 1. During filling, open the bleed screw of the auxiliary water tank, the coolant evaporator, and the transmission coolant vent screw until no bubbles are visible, then tighten them to enter the bleeding phase. 2. Connect the charger, turn the ignition switch to the second position, set the air conditioning fan to the lowest setting, adjust the temperature to the maximum, turn on the low beam headlights, and press the accelerator pedal for about ten seconds. You will then hear the sound of water being expelled from the auxiliary water tank. The water pump will run for a while to expel the air from the engine. 3. Note: Bleeding the electric water pump must be performed when the engine is in a cold state.
14
4
Share

What are the differences between Civic and Lamando?

Civic and Lamando mainly have the following differences: 1. Exterior: Lamando continues the design language of the Volkswagen family, with a flat front grille and a wide-body design that gives the Lamando an overall wide and flat impression; while the Civic follows Honda's family-style design, with a youthful, vibrant, and sporty appearance that appeals to many consumers. 2. Interior: The interior quality of the Civic is slightly inferior to that of the Lamando, and the plastic feel of the dashboard is a point of dissatisfaction for many, although its dashboard design still has a sporty touch.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.